From mboxrd@z Thu Jan 1 00:00:00 1970 From: Chin Liang See Date: Fri, 12 Sep 2014 02:21:25 -0500 Subject: [U-Boot] [PATCH] dw_mmc: cleanups In-Reply-To: <54110396.6030609@samsung.com> References: <20140905104948.GA2511@amd> <54110396.6030609@samsung.com> Message-ID: <1410506485.1904.19.camel@clsee-VirtualBox.altera.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hi, On Thu, 2014-09-11 at 11:06 +0900, Jaehoon Chung wrote: > Hi, Pavel. > > It looks good to me. > If you're ok, can i suggest one thing? > > On 09/05/2014 07:49 PM, Pavel Machek wrote: > > > > dw_mmc driver was responding to errors with debug(). Change that to > > prinf so that any errors are immediately obvious. Also adjust english > > in comments. > > > > Signed-off-by: Pavel Machek > > > > diff --git a/drivers/mmc/dw_mmc.c b/drivers/mmc/dw_mmc.c > > index 0df30bc..4c16e7f 100644 > > --- a/drivers/mmc/dw_mmc.c > > +++ b/drivers/mmc/dw_mmc.c > > @@ -260,7 +262,7 @@ static int dwmci_setup_bus(struct dwmci_host *host, u32 freq) > > do { > > status = dwmci_readl(host, DWMCI_CMD); > > if (timeout-- < 0) { > > - printf("TIMEOUT error!!\n"); > > + printf("dwmci_setup_bus: timeout!\n"); > > return -ETIMEDOUT; > > } > > } while (status & DWMCI_CMD_START); > > @@ -275,7 +277,7 @@ static int dwmci_setup_bus(struct dwmci_host *host, u32 freq) > > do { > > status = dwmci_readl(host, DWMCI_CMD); > > if (timeout-- < 0) { > > - printf("TIMEOUT error!!\n"); > > + printf("dwmci_setup_bus: timeout!\n"); > According to your the main purpose, this patch is goal that noticed where/what error is occurred. > Then i think good that add the "__LINE__". > Because there are same message like "dwmci_setup_bus: tiemout!\n" at some place. > > Then i think we don't need to discuss about this patch with Marek. :) > This patch looks good except need to distinguish the error location as pointed by Jaehoon. Thanks Chin Liang > Best Regards, > Jaehoon Chung >