[U-Boot] [PATCH v3] sunxi: Make DRAM_ODT_EN Kconfig setting a bool

[Ian Campbell <ijc+uboot@hellion.org.uk>]

On Tue, 2015-05-19 at 18:39 +0200, Hans de Goede wrote:
> Hi,
> 
> On 05/19/2015 04:13 PM, Ian Campbell wrote:
> > On Tue, 2015-05-19 at 14:56 +0200, Hans de Goede wrote:
> >> diff --git a/arch/arm/cpu/armv7/sunxi/dram_sun4i.c b/arch/arm/cpu/armv7/sunxi/dram_sun4i.c
> >> index c736fa3..f7b4915 100644
> >> --- a/arch/arm/cpu/armv7/sunxi/dram_sun4i.c
> >> +++ b/arch/arm/cpu/armv7/sunxi/dram_sun4i.c
> >> @@ -508,7 +508,7 @@ static void mctl_ddr3_initialize(void)
> >>   /*
> >>    * Perform impedance calibration on the DRAM controller side of the wire.
> >>    */
> >> -static void mctl_set_impedance(u32 zq, u32 odt_en)
> >> +static void mctl_set_impedance(u32 zq, bool odt_en)
> >>   {
> >>   	struct sunxi_dram_reg *dram = (struct sunxi_dram_reg *)SUNXI_DRAMC_BASE;
> >>   	u32 reg_val;
> >> @@ -556,7 +556,7 @@ static void mctl_set_impedance(u32 zq, u32 odt_en)
> >>   	clrbits_le32(&dram->zqcr0, DRAM_ZQCR0_ZCAL);
> >>
> >>   	/* Set I/O configure register */
> >> -	writel(DRAM_IOCR_ODT_EN(odt_en), &dram->iocr);
> >> +	writel(DRAM_IOCR_ODT_EN, &dram->iocr);
> >
> > I think at this point previously odt_en would always be 0x1 here (0x0
> > having been short circuited earlier).
> >
> > Whereas this...
> >
> >> -#define DRAM_IOCR_ODT_EN(n) ((((n) & 0x3) << 30) | ((n) & 0x3) << 0)
> >> -#define DRAM_IOCR_ODT_EN_MASK DRAM_IOCR_ODT_EN(0x3)
> >> +#define DRAM_IOCR_ODT_EN ((3 << 30) | (3 << 0))
> >
> > ... now behaves as if it were always 0x3.
> >
> > AFAICT up until now, at least with the in-tree defconfigs, odt_en was
> > always 0 for sun4i anyway, but this is a surprising change I think.
> 
> This is deliberate, as Siarhei explained in his reply to v2 the 2 bits
> we are setting here enable odt for the DQ resp. DQS lines, having them
> enabled for one but not the other does not really make sense.
> 
> I'll amend the commit message to explicitly mention this.

Thanks.

Ian.