[U-Boot] [PATCH] sunxi: Add new Mele_A1000G_quad defconfig

[Ian Campbell <ijc+uboot@hellion.org.uk>]

On Mon, 2015-06-01 at 17:01 +0200, Hans de Goede wrote:
> The Mele A1000G-quad and the Mele M9 have the same PCB, sofar we've been
> using the same defconfig (and dts on the kernel side) for both models.
> Unfortunately this does not work for the otg controller, on the M9 this
> is routed to a micro-usb connector on the outside, while as on the
> A1000G-quad it is connected to an usb to sata bridge.
> 
> This commit adds a new defconfig for the Mele-A1000G-quad to allow using
> different otg controller settings on the 2 boards.
> 
> Signed-off-by: Hans de Goede <hdegoede@redhat.com>
> diff --git a/configs/Mele_A1000G_quad_defconfig b/configs/Mele_A1000G_quad_defconfig
> new file mode 100644
> index 0000000..b93dcf5
> --- /dev/null
> +++ b/configs/Mele_A1000G_quad_defconfig
> @@ -0,0 +1,24 @@
> +# The Mele A1000G quad is yet another Allwinnner based Android top set box
> +# from Mele.
> +#
> +# It uses the same case as the original Mele A1000 and the same PCB as the M9,
> +# the  USM sata storage slot is connected via anusb to sata bridge connected to
> +# the otg controller, this renders the micro USB B receptacle non functional.
> +#
> +# It features an A31 SoC, 2G RAM, 16G Nand, 100Mbit ethernet, HDMI out,
> +# 3 USB A receptacles, 3.5 mm jack for analog audio out, optical spdif,
> +# RTL R8188EU (USB) wifi and a full size sdcard slot

Have you seen the thread "Clean all defconfigs with savedefconfig" which
we were copied on today? It seems that these comments are subject to
automated cleansing :-/

So we should put them somewhere else. Tom says there "in a README
somewhere".

Apart from that and assuming this matches the Linux patch you copied me
on and _that_ gets accepted:

        Acked-by: Ian Campbell <ijc@hellion.org.uk>

Ian.