[U-Boot] [PATCH] net/designware: revert MAC-address setup on init

[Alexey Brodkin <Alexey.Brodkin@synopsys.com>]

Hi Tom, Joe,

On Wed, 2015-07-01 at 22:22 +0800, Bin Meng wrote:
> Hi Alexey,
> 
> On Wed, Jul 1, 2015 at 9:59 PM, Alexey Brodkin
> <Alexey.Brodkin@synopsys.com> wrote:
> > http://git.denx.de/?p=u
> > -boot.git;a=patch;h=f566c9949fbdce2e09a900c5343ca9986e5ba360
> > broke DW GMAC operation if !DM_ETH because eth_write_hwaddr() 
> > doesn't
> > exist if !DM_NET.
> > 
> > As for DM_ETH case I'm still not sure if existing implementation 
> > will
> > fly.
> > 
> > The point is as it is said in the comment on "soft reset" that is
> > triggered with setting DMAMAC_SRST in "busmode" register HW address 
> > gets
> > reset as well. And we inevitably need to set HW address again.
> > 
> > So probably better solution is to move mentioned "soft-reset" from
> > "init" (that is used on start of any network activity) to 
> > "initialize"
> > (which is only executed once in "board_r" sequence). But that's a 
> > bit of
> > a different story and for now let's just get DW GMAC functional 
> > again.
> > 
> > Signed-off-by: Alexey Brodkin <abrodkin@synopsys.com>
> > Cc: Joe Hershberger <joe.hershberger@ni.com>
> > Cc: Michal Simek <michal.simek@xilinx.com>
> > Cc: Tom Rini <trini@konsulko.com>
> > ---
> >  drivers/net/designware.c | 4 ++++
> >  1 file changed, 4 insertions(+)
> > 
> > diff --git a/drivers/net/designware.c b/drivers/net/designware.c
> > index ae51cf3..07281a6 100644
> > --- a/drivers/net/designware.c
> > +++ b/drivers/net/designware.c
> > @@ -243,6 +243,10 @@ static int _dw_eth_init(struct dw_eth_dev 
> > *priv, u8 *enetaddr)
> >                 mdelay(100);
> >         };
> > 
> > +       /* Soft reset above clears HW address registers.
> > +        * So we have to set it here once again */
> > +       _dw_write_hwaddr(priv, enetaddr);
> > +
> >         rx_descs_init(priv);
> >         tx_descs_init(priv);
> > 
> > --
> 
> There is already a patch submitted. Please check
> http://patchwork.ozlabs.org/patch/484214/

Any chance for mentioned patch "net: designware: Program MAC address to
hardware after soft reset" to be applied?

This really fixes GMAC operation and it would be nice to have this fix
in upcoming release.

-Alexey