[U-Boot] [PATCH 1/3] spi: xilinx_spi: Fix to configure CPOL, CPHA mask

[Jagan Teki <jteki@openedev.com>]

priv->mode is initialized when .set_speed triggers
with mode value, so checking mode for configuring
CPOL, CPHA using priv->mode is invalid hence use
mode from .set_speed argument, and at the end
priv->mode will initialized with mode.

This patch also replaces formatting string to use
speed instead of mode in .set_speed ops.

Signed-off-by: Jagan Teki <jteki@openedev.com>
---
 drivers/spi/xilinx_spi.c | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/drivers/spi/xilinx_spi.c b/drivers/spi/xilinx_spi.c
index 6c21acd..8ccc578 100644
--- a/drivers/spi/xilinx_spi.c
+++ b/drivers/spi/xilinx_spi.c
@@ -247,7 +247,7 @@ static int xilinx_spi_set_speed(struct udevice *bus, uint speed)
 
 	priv->freq = speed;
 
-	debug("xilinx_spi_set_speed: regs=%p, mode=%d\n", priv->regs,
+	debug("xilinx_spi_set_speed: regs=%p, speed=%d\n", priv->regs,
 	      priv->freq);
 
 	return 0;
@@ -260,13 +260,13 @@ static int xilinx_spi_set_mode(struct udevice *bus, uint mode)
 	uint32_t spicr;
 
 	spicr = readl(&regs->spicr);
-	if (priv->mode & SPI_LSB_FIRST)
+	if (mode & SPI_LSB_FIRST)
 		spicr |= SPICR_LSB_FIRST;
-	if (priv->mode & SPI_CPHA)
+	if (mode & SPI_CPHA)
 		spicr |= SPICR_CPHA;
-	if (priv->mode & SPI_CPOL)
+	if (mode & SPI_CPOL)
 		spicr |= SPICR_CPOL;
-	if (priv->mode & SPI_LOOP)
+	if (mode & SPI_LOOP)
 		spicr |= SPICR_LOOP;
 
 	writel(spicr, &regs->spicr);
-- 
1.9.1