[U-Boot] [PATCH 3/4] spi: cadence_qspi: Ensure check for max frequency in place

[Chin Liang See <clsee@altera.com>]

Hi,

On Tue, 2015-09-08 at 17:51 +0530, Jagan Teki wrote:
> On 8 September 2015 at 06:48, Chin Liang See <clsee@altera.com> wrote:
> > Ensure the intended SCLK frequency not exceeding the maximum
> > frequency. If that happen, SCLK will set to maximum frequency.
> >
> > Signed-off-by: Chin Liang See <clsee@altera.com>
> > Cc: Dinh Nguyen <dinguyen@opensource.altera.com>
> > Cc: Dinh Nguyen <dinh.linux@gmail.com>
> > Cc: Marek Vasut <marex@denx.de>
> > Cc: Stefan Roese <sr@denx.de>
> > Cc: Vikas Manocha <vikas.manocha@st.com>
> > Cc: Jagannadh Teki <jteki@openedev.com>
> > Cc: Pavel Machek <pavel@denx.de>
> > ---
> >  drivers/spi/cadence_qspi.c |    5 +++++
> >  1 files changed, 5 insertions(+), 0 deletions(-)
> >
> > diff --git a/drivers/spi/cadence_qspi.c b/drivers/spi/cadence_qspi.c
> > index 8c0f7dd..f430b5d 100644
> > --- a/drivers/spi/cadence_qspi.c
> > +++ b/drivers/spi/cadence_qspi.c
> > @@ -127,6 +127,11 @@ static int cadence_spi_set_speed(struct udevice *bus, uint hz)
> >         struct cadence_spi_priv *priv = dev_get_priv(bus);
> >         int err;
> >
> > +       if (hz > plat->max_hz) {
> > +               hz = plat->max_hz;
> > +               puts("SF: Default to maximum supported SCLK frequency\n");
> 
> This print mayn't require just assign plat->max_hz enough.

Sure, I can update that.

Thanks
Chin Liang

> 
> Reviewed-by: Jagan Teki <jteki@openedev.com>
> 
> > +       }
> > +
> >         /* Disable QSPI */
> >         cadence_qspi_apb_controller_disable(priv->regbase);
> 
> thanks!