From mboxrd@z Thu Jan 1 00:00:00 1970 From: Scott Wood Date: Sat, 12 Sep 2015 09:36:54 -0500 Subject: [U-Boot] [U-Boot, 1/4, v2] mtd: nand: fsmc: Add BCH4 SW ECC support for SPEAr600 In-Reply-To: <20150912125043.GT26226@bill-the-cat> References: <1441196952-13885-1-git-send-email-sr@denx.de> <20150912125043.GT26226@bill-the-cat> Message-ID: <1442068614.2909.58.camel@freescale.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Sat, 2015-09-12 at 08:50 -0400, Tom Rini wrote: > On Wed, Sep 02, 2015 at 02:29:12PM +0200, Stefan Roese wrote: > > > This patch adds support for 4-bit ECC BCH4 for the SPEAr600 SoC. This can > > be used by boards equipped with a NAND chip that requires 4-bit ECC > > strength. > > The SPEAr600 HW ECC only supports 1-bit ECC strength. > > > > To enable SW BCH4, you need to specify this in your config header: > > > > #define CONFIG_NAND_ECC_BCH > > #define CONFIG_BCH > > > > And use the command "nandecc bch4" to select this ECC scheme upon runtime. > > > > Tested on SPEAr600 x600 board. > > > > Signed-off-by: Stefan Roese > > Cc: Scott Wood > > Acked-by: Viresh Kumar > > Applied to u-boot/master, thanks! > There's a v3, and some minor comments even on that one... -Scott