From mboxrd@z Thu Jan 1 00:00:00 1970 From: Jagan Teki Date: Mon, 14 Dec 2015 12:27:09 +0530 Subject: [U-Boot] [PATCH v2 2/5] spi: make mode visible to both dm and non-dm In-Reply-To: <1450076232-31884-1-git-send-email-jteki@openedev.com> References: <1450076232-31884-1-git-send-email-jteki@openedev.com> Message-ID: <1450076232-31884-2-git-send-email-jteki@openedev.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Couldn't find the exact reason to define 'mode' for dm, probably it is not using in non-dm drivers but it need to visible both dm and non-dm as mode data is getting dereferred in spi flash core ie common to both. Cc: Bin Meng Cc: Simon Glass Signed-off-by: Jagan Teki --- Changes for v2: - newly added include/spi.h | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/include/spi.h b/include/spi.h index b4d2723..713bab9 100644 --- a/include/spi.h +++ b/include/spi.h @@ -99,13 +99,13 @@ struct dm_spi_slave_platdata { * * @dev: SPI slave device * @max_hz: Maximum speed for this slave - * @mode: SPI mode to use for this slave (see SPI mode flags) * @speed: Current bus speed. This is 0 until the bus is first * claimed. * @bus: ID of the bus that the slave is attached to. For * driver model this is the sequence number of the SPI * bus (bus->seq) so does not need to be stored * @cs: ID of the chip select connected to the slave. + * @mode: SPI mode to use for this slave (see SPI mode flags) * @op_mode_rx: SPI RX operation mode. * @op_mode_tx: SPI TX operation mode. * @wordlen: Size of SPI word in number of bits @@ -120,11 +120,11 @@ struct spi_slave { struct udevice *dev; /* struct spi_slave is dev->parentdata */ uint max_hz; uint speed; - uint mode; #else unsigned int bus; unsigned int cs; #endif + u8 mode; u8 op_mode_rx; u8 op_mode_tx; unsigned int wordlen; -- 1.9.1