[U-Boot] [PATCH v4 3/5] dm: ns16550: Don't map_physmem for I/O ports

[Daniel Schwierzeck <daniel.schwierzeck@gmail.com>]

From: Paul Burton <paul.burton@imgtec.com>

If the UART is to be accessed using I/O port accessors (inb & outb) then
using map_physmem doesn't make sense, since it operates in a different
memory space. Remove the call to map_physmem when
CONFIG_SYS_NS16550_PORT_MAPPED is defined, allowing I/O port addresses
to not be mangled by the incorrect mapping.

Signed-off-by: Paul Burton <paul.burton@imgtec.com>
Signed-off-by: Daniel Schwierzeck <daniel.schwierzeck@gmail.com>
---

Updated patch due to discussion in:
http://thread.gmane.org/gmane.comp.boot-loaders.u-boot/261776/focus=262627

Changes in v4: 
- Only do map_physmem() once in ns16550_serial_ofdata_to_platdata().
Changes in v3: None
Changes in v2:
- New patch, part of a simplified approach tackling only a single Malta UART.


 drivers/serial/ns16550.c | 10 ++++++++--
 1 file changed, 8 insertions(+), 2 deletions(-)

diff --git a/drivers/serial/ns16550.c b/drivers/serial/ns16550.c
index 28da9dd..b6eac1c 100644
--- a/drivers/serial/ns16550.c
+++ b/drivers/serial/ns16550.c
@@ -100,7 +100,8 @@ static void ns16550_writeb(NS16550_t port, int offset, int value)
 	unsigned char *addr;
 
 	offset *= 1 << plat->reg_shift;
-	addr = map_physmem(plat->base, 0, MAP_NOCACHE) + offset;
+	addr = (unsigned char *)plat->base + offset;
+
 	/*
 	 * As far as we know it doesn't make sense to support selection of
 	 * these options at run-time, so use the existing CONFIG options.
@@ -114,7 +115,7 @@ static int ns16550_readb(NS16550_t port, int offset)
 	unsigned char *addr;
 
 	offset *= 1 << plat->reg_shift;
-	addr = map_physmem(plat->base, 0, MAP_NOCACHE) + offset;
+	addr = (unsigned char *)plat->base + offset;
 
 	return serial_in_shift(addr + plat->reg_offset, plat->reg_shift);
 }
@@ -400,7 +401,12 @@ int ns16550_serial_ofdata_to_platdata(struct udevice *dev)
 	if (addr == FDT_ADDR_T_NONE)
 		return -EINVAL;
 
+#ifdef CONFIG_SYS_NS16550_PORT_MAPPED
 	plat->base = addr;
+#else
+	plat->base = map_physmem(addr, 0, MAP_NOCACHE);
+#endif
+
 	plat->reg_offset = fdtdec_get_int(gd->fdt_blob, dev->of_offset,
 				     "reg-offset", 0);
 	plat->reg_shift = fdtdec_get_int(gd->fdt_blob, dev->of_offset,
-- 
2.7.4