From mboxrd@z Thu Jan 1 00:00:00 1970 From: Dalon Westergreen Date: Fri, 10 Feb 2017 13:53:52 -0800 Subject: [U-Boot] [PATCH v6 1/3] SPL: add support to boot from a partition type In-Reply-To: <20170210214338.GC26129@bill-the-cat> References: <1486671604-16203-1-git-send-email-dwesterg@gmail.com> <1486671604-16203-2-git-send-email-dwesterg@gmail.com> <20170210214338.GC26129@bill-the-cat> Message-ID: <1486763632.6338.132.camel@gmail.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Fri, 2017-02-10 at 16:43 -0500, Tom Rini wrote: > On Thu, Feb 09, 2017 at 12:20:02PM -0800, Dalon Westergreen wrote: > > > > > the socfpga bootrom supports mmc booting from either a raw image > > starting at 0x0, or from a partition of type 0xa2.??This patch > > adds support for locating the boot image in the first type 0xa2 > > partition found. > > > > Assigned a partition number of -1 will cause a search for a > > partition of type CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION_TYPE > > and use it to find the u-boot image > > > > Signed-off-by: Dalon Westergreen > [snip] > > > > +config SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION_TYPE > > + hex "Partition Type on the MMC to load U-Boot from" > > + depends on SPL && SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION_TYPE > > + default 0xa2 Works for me, only reason i did this was so that it didnt default to 0x0 for other devices. > > This default should depend on ARCH_SOCFPGA as well. > > _______________________________________________ > U-Boot mailing list > U-Boot at lists.denx.de > http://lists.denx.de/mailman/listinfo/u-boot