[U-Boot] [PATCH v6 1/3] SPL: add support to boot from a partition type

[Dalon Westergreen <dwesterg@gmail.com>]

On Fri, 2017-02-10 at 23:08 +0100, Marek Vasut wrote:
> On 02/10/2017 10:43 PM, Tom Rini wrote:
> > 
> > On Thu, Feb 09, 2017 at 12:20:02PM -0800, Dalon Westergreen wrote:
> > 
> > > 
> > > the socfpga bootrom supports mmc booting from either a raw image
> > > starting at 0x0, or from a partition of type 0xa2.??This patch
> > > adds support for locating the boot image in the first type 0xa2
> > > partition found.
> > > 
> > > Assigned a partition number of -1 will cause a search for a
> > > partition of type CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION_TYPE
> > > and use it to find the u-boot image
> > > 
> > > Signed-off-by: Dalon Westergreen <dwesterg@gmail.com>
> > [snip]
> > > 
> > > +config SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION_TYPE
> > > +	hex "Partition Type on the MMC to load U-Boot from"
> > > +	depends on SPL && SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION_TYPE
> > > +	default 0xa2
> > 
> > This default should depend on ARCH_SOCFPGA as well.
> > 
> IMO this should be set by ARCH_SOCFPGA in arch/arm/socfpga/Kconfig

just saw this, i can move it there now.
>