From mboxrd@z Thu Jan 1 00:00:00 1970 From: Dalon Westergreen Date: Fri, 10 Feb 2017 15:38:40 -0800 Subject: [U-Boot] [PATCH v6 1/3] SPL: add support to boot from a partition type In-Reply-To: References: <1486671604-16203-1-git-send-email-dwesterg@gmail.com> <1486671604-16203-2-git-send-email-dwesterg@gmail.com> <20170210214338.GC26129@bill-the-cat> Message-ID: <1486769920.6338.173.camel@linux.intel.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Fri, 2017-02-10 at 22:59 +0100, Alexander Graf wrote: > > > > > Am 10.02.2017 um 22:43 schrieb Tom Rini : > > > > > > > > On Thu, Feb 09, 2017 at 12:20:02PM -0800, Dalon Westergreen wrote: > > > > > > the socfpga bootrom supports mmc booting from either a raw image > > > starting at 0x0, or from a partition of type 0xa2.??This patch > > > adds support for locating the boot image in the first type 0xa2 > > > partition found. > > > > > > Assigned a partition number of -1 will cause a search for a > > > partition of type CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION_TYPE > > > and use it to find the u-boot image > > > > > > Signed-off-by: Dalon Westergreen > > [snip] > > > > > > +config SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION_TYPE > > > +????hex "Partition Type on the MMC to load U-Boot from" > > > +????depends on SPL && SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION_TYPE > > > +????default 0xa2 > > > > This default should depend on ARCH_SOCFPGA as well. > > We discussed this in earlier review. IMHO 0xa2 is as good a default as 0x0 for > non-socfpga targets. > > Or asked differently: What default should we have for others? :) i moved this to arch/arm/mach-socfpga per marek's suggestion. > > Alex > > > _______________________________________________ > U-Boot mailing list > U-Boot at lists.denx.de > http://lists.denx.de/mailman/listinfo/u-boot