[U-Boot] [PATCH] video: mxsfb: Fix reset hang when videomode variable is not present

[Fabio Estevam <festevam@gmail.com>]

From: Fabio Estevam <fabio.estevam@nxp.com>

Currently the system hangs when the 'videomode' variable is not present:

=> setenv videomode
=> saveenv
=> reset

(Board hangs)

lcdif_power_down() assumes that the LCDIF controller has been properly
configured and enabled, which may not be true.

To fix this issue check whether video_hw_init() succeeded or not and only
perform the LCDIF shutdown when the controller has been properly enabled.

Tested on a imx7dsabresd board.

Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
---
 drivers/video/mxsfb.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/drivers/video/mxsfb.c b/drivers/video/mxsfb.c
index 3cc03ca..83fd9aa 100644
--- a/drivers/video/mxsfb.c
+++ b/drivers/video/mxsfb.c
@@ -136,6 +136,9 @@ void lcdif_power_down(void)
 	struct mxs_lcdif_regs *regs = (struct mxs_lcdif_regs *)MXS_LCDIF_BASE;
 	int timeout = 1000000;
 
+	if (!video_hw_init())
+		return;
+
 	writel(panel.frameAdrs, &regs->hw_lcdif_cur_buf_reg);
 	writel(panel.frameAdrs, &regs->hw_lcdif_next_buf_reg);
 	writel(LCDIF_CTRL1_VSYNC_EDGE_IRQ, &regs->hw_lcdif_ctrl1_clr);
-- 
2.7.4