[U-Boot] [PATCH v8 5/7] drivers: Enable FPGA driver build on SPL

[Chee, Tien Fong <tien.fong.chee@intel.com>]

On Sel, 2017-06-06 at 10:35 +0200, Marek Vasut wrote:
> On 06/06/2017 10:26 AM, Chee, Tien Fong wrote:
> > 
> > On Sel, 2017-06-06 at 10:03 +0200, Marek Vasut wrote:
> > > 
> > > On 06/06/2017 08:35 AM, tien.fong.chee at intel.com wrote:
> > > > 
> > > > 
> > > > From: Tien Fong Chee <tien.fong.chee@intel.com>
> > > > 
> > > > Enable FPGA driver build for SPL because FPGA driver is needed
> > > > for
> > > > SPL
> > > > to configure and getting DDR up before loading U-boot into DDR
> > > > and
> > > > booting from there.
> > > > 
> > > > FPGA driver build on SPL must be enabled 1st before applying
> > > > next
> > > > patch to
> > > > avoid build failed, because fpga_manager which would be moved
> > > > to
> > > > drivers/fpga by next patch are required in SPL.
> > > > 
> > > > Signed-off-by: Tien Fong Chee <tien.fong.chee@intel.com>
> > > You should probably swap this and 4/5 ?
> > > 
> > I have no strong opinion about this swapping. Don't you think that
> > it's
> > much more sensible having enabling FPGA support on
> > SPL(configuration
> > 1st), then only enable the build?
> No, we add all the fixes first, then code and then enable it in
> configuration.
> 
Okay, then i will swap between patch 4 and patch 5.
> > 
> > > 
> > > > 
> > > > 
> > > > ---
> > > >  drivers/Makefile | 1 +
> > > >  1 file changed, 1 insertion(+)
> > > > 
> > > > diff --git a/drivers/Makefile b/drivers/Makefile
> > > > index 64c39d3..4478212 100644
> > > > --- a/drivers/Makefile
> > > > +++ b/drivers/Makefile
> > > > @@ -48,6 +48,7 @@ obj-$(CONFIG_OMAP_USB_PHY) += usb/phy/
> > > >  obj-$(CONFIG_SPL_SATA_SUPPORT) += block/
> > > >  obj-$(CONFIG_SPL_USB_HOST_SUPPORT) += block/
> > > >  obj-$(CONFIG_SPL_MMC_SUPPORT) += block/
> > > > +obj-$(CONFIG_SPL_FPGA_SUPPORT) += fpga/
> > > >  endif
> > > >  
> > > >  ifdef CONFIG_TPL_BUILD
> > > > 
>