[U-Boot] [PATCH v2 3/3] x86: Add Intel Edison board files

[Andy Shevchenko <andriy.shevchenko@linux.intel.com>]

On Thu, 2017-07-06 at 12:07 +0800, Bin Meng wrote:
> Hi Andy,
> 
> On Thu, Jul 6, 2017 at 4:56 AM, Andy Shevchenko
> <andriy.shevchenko@linux.intel.com> wrote:
> > Add Intel Edison board which is using U-Boot.
> 

Thanks for review, my answers below.

> Thank you for your efforts to bring edition support upstream! Looks
> quite clean. A few comments below.

I hope to see it soon there!

> > +config SYS_USB_OTG_BASE
> > +       hex
> > +       default 0xf9100000
> 
> Can this otg controller be put into device tree, like other
> peripherals?

I will check the possibility.


> > diff --git a/board/intel/edison/edison_start.S
> > b/board/intel/edison/edison_start.S
> 
> This file should be renamed to just start.S

Done.

> > +U-boot is a main bootloader on Intel Edison board.
> 
> U-Boot

Fixed.

> Are there instructions on how to program U-Boot on a board that does
> not have pre-flashed U-Boot? or in a situation that users flashed a
> bad image that makes the board brick.

We assume that board is supplied with official image. There is official
documentation how to "unbrick" board to the stock state. So, I consider
it out of scope of U-Boot documentation.

> > +/*-----------------------------------------------------------------
> > ------
> 
> nits: /* Boot */

Fixed (all cases).

-- 
Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Intel Finland Oy