[U-Boot] [PATCH 1/2] net: fec_mxc: Fix setting of RCR for xMII

["Benoît Thébaudeau" <benoit.thebaudeau@advansee.com>]

At least on i.MX25, the RMII mode did not work, which is fixed by this patch.

The MII_MODE bit of the FEC RCR register means xMII, i.e. 'not 7-wire', so set
it accordingly.

According to the xMII and 7-wire (aka GPSI) standards, full duplex should be
available on xMII, but not on 7-wire, so set FCE accordingly. The FEC may
support full duplex for 7-wire too, but the reference manual does not say that,
so avoid an invalid assumption. Actually, the choice between half and full
duplex also depends on the endpoint/switch/repeater configuration, so a config
option could be added for that, but there has been no need for it so far.

Signed-off-by: Beno?t Th?baudeau <benoit.thebaudeau@advansee.com>
Cc: Joe Hershberger <joe.hershberger@gmail.com>
Cc: Stefano Babic <sbabic@denx.de>
---
 .../drivers/net/fec_mxc.c                          |    8 +++-----
 1 file changed, 3 insertions(+), 5 deletions(-)

diff --git u-boot-66714b1.orig/drivers/net/fec_mxc.c u-boot-66714b1/drivers/net/fec_mxc.c
index eee41d7..c64a223 100644
--- u-boot-66714b1.orig/drivers/net/fec_mxc.c
+++ u-boot-66714b1/drivers/net/fec_mxc.c
@@ -424,14 +424,12 @@ static void fec_reg_setup(struct fec_priv *fec)
 
 	/* Start with frame length = 1518, common for all modes. */
 	rcntrl = PKTSIZE << FEC_RCNTRL_MAX_FL_SHIFT;
-	if (fec->xcv_type == SEVENWIRE)
-		rcntrl |= FEC_RCNTRL_FCE;
-	else if (fec->xcv_type == RGMII)
+	if (fec->xcv_type != SEVENWIRE)		/* xMII modes */
+		rcntrl |= FEC_RCNTRL_FCE | FEC_RCNTRL_MII_MODE;
+	if (fec->xcv_type == RGMII)
 		rcntrl |= FEC_RCNTRL_RGMII;
 	else if (fec->xcv_type == RMII)
 		rcntrl |= FEC_RCNTRL_RMII;
-	else	/* MII mode */
-		rcntrl |= FEC_RCNTRL_FCE | FEC_RCNTRL_MII_MODE;
 
 	writel(rcntrl, &fec->eth->r_cntrl);
 }