[U-Boot] [PATCH] FSL PCI: Configure PCIe reference ratio

[Joakim Tjernlund <Joakim.Tjernlund@infinera.com>]

On Tue, 2017-11-21 at 17:23 +0000, York Sun wrote:
> CAUTION: This email originated from outside of the organization. Do not click links or open attachments unless you recognize the sender and know the content is safe.
> 
> 
> On 11/21/2017 09:18 AM, Joakim Tjernlund wrote:
> > On Tue, 2017-09-12 at 19:56 +0200, Joakim Tjernlund wrote:
> > > Most FSL PCIe controllers expects 333 MHz PCI reference clock.
> > > This clock is derived from the CCB but in many cases the ref.
> > > clock is not 333 MHz and a divisor needs to be configured.
> > > 
> > > This adds PEX_CCB_DIV #define which can be defined for each
> > > type of CPU/platform.
> > > 
> > > Signed-off-by: Joakim Tjernlund <joakim.tjernlund@infinera.com>
> > > ---
> > >  drivers/pci/fsl_pci_init.c | 6 ++++++
> > >  1 file changed, 6 insertions(+)
> > > 
> > > diff --git a/drivers/pci/fsl_pci_init.c b/drivers/pci/fsl_pci_init.c
> > > index 52792dcd59..4d00b3f26c 100644
> > > --- a/drivers/pci/fsl_pci_init.c
> > > +++ b/drivers/pci/fsl_pci_init.c
> > > @@ -322,6 +322,12 @@ void fsl_pci_init(struct pci_controller *hose, struct fsl_pci_info *pci_info)
> > > 
> > >      pci_setup_indirect(hose, cfg_addr, cfg_data);
> > > 
> > > +#ifdef PEX_CCB_DIV
> > > +    /* Configure the PCIE controller core clock ratio */
> > > +    pci_hose_write_config_dword(hose, dev, 0x440,
> > > +                                ((gd->bus_clk / 1000000) *
> > > +                                 (16 / PEX_CCB_DIV)) / 333);
> > > +#endif
> > >      block_rev = in_be32(&pci->block_rev1);
> > >      if (PEX_IP_BLK_REV_2_2 <= block_rev) {
> > >              pi = &pci->pit[2];      /* 0xDC0 */
> > 
> > Ping?
> > 
> >  Jocke
> > 
> 
> I believe Mingkai's last comment was "to add the PCIe clock in gd".

Right, I seem to have forgotten to comment on that ...
Why add that complexity/bloat? This is a constant defined by the CPU/SOC so
it makes perfect sense to just #define it.

 Jocke