[U-Boot] [PATCH v7 15/19] nand: mxc: Switch NAND SPL to generic SPL

["Benoît Thébaudeau" <benoit.thebaudeau@advansee.com>]

Hi Fabio,

On Friday, February 22, 2013 8:30:36 PM, Fabio Estevam wrote:
> On Fri, Feb 22, 2013 at 4:14 PM, Fabio Estevam <festevam@gmail.com> wrote:
> 
> > Just tested your patch series on a mx31pdk, but unfortunately it does
> > not fix mx31pdk boot.
> >
> > I will start looking at it, but any suggestion is welcome.
> 
> Ok, just changed to a proper toolchain and the result is a bit better now:
> 
> U-Boot 2013.01 (Feb 22 2013 - 16:25:48)
> 
> CPU:   Freescale i.MX31 rev 2.0 at 532 MHz.
> Reset cause: POR
> Board: MX31PDK
> DRAM:  128 MiB
> 
> (hangs here).

It looks very much like the issue that Marek had on i.MX53 (which self-resolved
for an unknown reason).

Try to enable the debug trace to see if anything else is printed after
display_dram_config(). I would especially be interested in:
        debug("relocation Offset is: %08lx\n", gd->reloc_off);
        debug("monitor flash len: %08lX\n", monitor_flash_len);

We should also check if CONFIG_SPL_TEXT_BASE and CONFIG_SYS_TEXT_BASE don't
overlap with something depending on code size. That's especially true for
CONFIG_SYS_TEXT_BASE.

After that, JTAG if no clue left... ;(

Best regards,
Beno?t