[U-Boot] [PATCH 6/9] ARM: socfpga: Set default DTB address on A10

[Chee, Tien Fong <tien.fong.chee@intel.com>]

On Wed, 2018-11-21 at 15:22 +0100, Marek Vasut wrote:
> On 11/21/2018 11:41 AM, tien.fong.chee at intel.com wrote:
> > 
> > From: Tien Fong Chee <tien.fong.chee@intel.com>
> Again, not your patch, please don't change authorship.
> 
> http://git.denx.de/?p=u-boot/u-boot-socfpga.git;a=commit;h=eb32e56886
> 9b5f91fe34efb2642875a8da5f0ebd
> 
> > 
> > Set default DT blob address on A10 SoCDK, since this SoC uses OF
> > separate configuration. The 0xf0000 address is just below the text
> > base and still leaves enough room for the DT to grow.
> Why is this needed ?
This patch i also cherry picked from sdmmc_next custodian. I think you
put this for FIT implementation? I saw there is load property
"0xf00000" defined for fdt in .its.
> 
> > 
> > Signed-off-by: Marek Vasut <marex@denx.de>
> > Signed-off-by: Tien Fong Chee <tien.fong.chee@intel.com>
> > ---
> >  arch/arm/mach-socfpga/board.c |    8 ++++++++
> >  1 files changed, 8 insertions(+), 0 deletions(-)
> > 
> > diff --git a/arch/arm/mach-socfpga/board.c b/arch/arm/mach-
> > socfpga/board.c
> > index 7c8c05c..436a8a8 100644
> > --- a/arch/arm/mach-socfpga/board.c
> > +++ b/arch/arm/mach-socfpga/board.c
> > @@ -86,3 +86,11 @@ int g_dnl_board_usb_cable_connected(void)
> >  	return 1;
> >  }
> >  #endif
> > +
> > +#if defined(CONFIG_TARGET_SOCFPGA_ARRIA10) && \
> > +!defined(CONFIG_SPL_BUILD) && defined(CONFIG_OF_SEPARATE)
> > +void *board_fdt_blob_setup(void)
> > +{
> > +	return (void *)0xf00000;
> > +}
> > +#endif
> > 
>