[U-Boot] [PATCH] arm: exynos: odroid: Fix build if BOARD_TYPES are not set

[Krzysztof Kozlowski <krzk@kernel.org>]

CONFIG_BOARD_TYPES is necessary for Odroid X/X2/U3 boards to detect
proper revision.  However building should succeed even without it.
While moving code around, document also the reference clock selection.

This fixes the build error without CONFIG_BOARD_TYPES:

    board/samsung/odroid/odroid.c: In function 'board_usb_init':
    board/samsung/odroid/odroid.c:473:8: error: 'gd_t' {aka 'volatile struct global_data'} has no member named 'board_type'
      if (gd->board_type == ODROID_TYPE_U3)
            ^~

Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
---
 board/samsung/odroid/odroid.c | 27 +++++++++++++++++++++------
 1 file changed, 21 insertions(+), 6 deletions(-)

diff --git a/board/samsung/odroid/odroid.c b/board/samsung/odroid/odroid.c
index 552333fe869d..b11d99223346 100644
--- a/board/samsung/odroid/odroid.c
+++ b/board/samsung/odroid/odroid.c
@@ -462,18 +462,33 @@ struct dwc2_plat_otg_data s5pc210_otg_data = {
 
 #if defined(CONFIG_USB_GADGET) || defined(CONFIG_CMD_USB)
 
+static void set_usb3503_ref_clk(void)
+{
+#ifdef CONFIG_BOARD_TYPES
+	/*
+	 * gpx3-0 chooses primary (low) or secondary (high) reference clock
+	 * frequencies table.  The choice of clock is done through hard-wired
+	 * REF_SEL pins.
+	 * The Odroid Us have reference clock at 24 MHz (00 entry from secondary
+	 * table) and Odroid Xs have it at 26 MHz (01 entry from primary table).
+	 */
+	if (gd->board_type == ODROID_TYPE_U3)
+		gpio_direction_output(EXYNOS4X12_GPIO_X30, 0);
+	else
+		gpio_direction_output(EXYNOS4X12_GPIO_X30, 1);
+#else
+	/* Choose Odroid Xs frequency without board types */
+	gpio_direction_output(EXYNOS4X12_GPIO_X30, 1);
+#endif /* CONFIG_BOARD_TYPES */
+}
+
 int board_usb_init(int index, enum usb_init_type init)
 {
 #ifdef CONFIG_CMD_USB
 	struct udevice *dev;
 	int ret;
 
-	/* Set Ref freq 0 => 24MHz, 1 => 26MHz*/
-	/* Odroid Us have it at 24MHz, Odroid Xs at 26MHz */
-	if (gd->board_type == ODROID_TYPE_U3)
-		gpio_direction_output(EXYNOS4X12_GPIO_X30, 0);
-	else
-		gpio_direction_output(EXYNOS4X12_GPIO_X30, 1);
+	set_usb3503_ref_clk();
 
 	/* Disconnect, Reset, Connect */
 	gpio_direction_output(EXYNOS4X12_GPIO_X34, 0);
-- 
2.7.4