[U-Boot] Xilinx Zed Board resets with Master

[Tim Sander <tim@krieglstein.org>]

Hi
> > On 03/27/2014 05:32 PM, Tim Sander wrote:
> > > Hi Michal
> > > 
> > > Am Donnerstag, 27. M?rz 2014, 14:17:41 schrieb Michal Simek:
> > >>>>>> Please check and may be you can try u-boot-dtb.elf.
> > >>>>> 
> > >>>>> Mh,  don't know how to create this kind of file?
> > >>>> 
> > >>>> Jagan maybe knows more but I don't think u-boot-dtb.elf is generated.
> > >>>> Just u-boot-dtb.bin is generated which should be copied as data file
> > >>>> in xmd and not sure if binary file can be directly used for bootgen.
> > > 
> > > If adding the dtb file in the boot.bif file is not the right way and no
> > > elf file with dtb is generated: What is the right way to generate an
> > > image for use with the SD-Card?
> > 
> > you can just use static u-boot configuration.
> 
> I assume you mean static configuration a config with OF_CONTROL disabled.
> Ok, i have tried to boot that with bootgen. That does not work.
> Loading that into memory and booting it from within the debugger works
> though. In both cases with or without OF_CONTROL enabled.
> 
> > I have never tried to add dtb as partition to boot.bin.
> > If you want to use this dtb driver u-boot I would suggest you
> > to look at u-boot SPL which should be able to handle binary formats
> > with dtbs.
> 
> So my main focus is to test CONFIG_ARMV7_NONSEC to boot linux in
> normal mode. I wanted to test recent mainline with that. So focusing on
> u-boot SPL is to far off my targets. So i am happy with hardware debugger
> loadeing for the time beeing.
> 
> Getting back to CONFIG_ARMV7_NONSEC. This is unfortunatly not working with
> the Zynq.  Currently the board switches to monitor mode but when the u-boot
> switches to normal mode it jumps to PC:0xc  (LR:0x10) which seems like a
> data abort exeption or some other secure mode violation exception?
> Is there a good way to find out what happened? I am currently stuck with
> this and my local FAE has also no idea. Attached is a patch which at least
> works until the return from the monitor mode.
Just a small information: I can boot a OF_CONTROL on a RevC Zynq 
Board but not Rev. D. So i can at least confirm that a board with RevC boots a 
mainline u-boot with OF_CONTROL disabled. I have no idea why the bootgen for 
the Rev. D board fails even if i have replaced the bitstream for the non eng. 
sample FPGA. But at least that also works when loaded with an HW-Debugger.

Best regards
Tim