From: Kurt Miller <kurt@intricatesoftware.com>
To: u-boot@lists.denx.de
Subject: [PATCH 0/6] rockchip: rk3328: sync dts and add ROC-RK3328-CC board
Date: Fri, 27 Mar 2020 11:07:35 -0400 [thread overview]
Message-ID: <1585321655.5148.23.camel@intricatesoftware.com> (raw)
In-Reply-To: <20200327044130.8763-1-wens@kernel.org>
On Fri, 2020-03-27 at 12:41 +0800, Chen-Yu Tsai wrote:
> From: Chen-Yu Tsai <wens@csie.org>
>
> Hi everyone,
>
> This series adds proper support for Firefly / Libre Computer ROC-RK3328-CC
> single board computer.
>
> The ROC-RK3328-CC from Firefly and Libre Computer Project is a credit
> card size development board based on the Rockchip RK3328 SoC, with:
>
> ? - 1/2/4 GB DDR4 DRAM
> ? - eMMC connector for optional module
> ? - micro SD card slot
> ? - 1 x USB 3.0 host port
> ? - 2 x USB 2.0 host port
> ? - 1 x USB 2.0 OTG port
> ? - HDMI video output
> ? - TRRS connector with audio and composite video output
> ? - gigabit Ethernet
> ? - consumer IR receiver
> ? - debug UART pins
>
> Originally I started with Loic's patches, and syncing the device tree
> files from Linux. That didn't get very far, with SPL failing to detect
> the SD card. Examining the schematics and internal state of GRF and
> GPIOs, I realized that the logic for the SD card power enable switch
> is opposite that of what the SD card controller's SDMMC0_PWREN pin
> would use. Instead, directly using the GPIO is required.
>
> Thus this series creates a special target for this board to handle
> muxing this specific pin to GPIO state. The GPIO is left in input mode,
> letting the external pull-down work its magic.
>
> Along the way, there are some clean-ups of existing dts files, moving
> U-boot only features to -u-boot.dtsi files, and then a wholesale sync
> from Linux. Only boards already existing in U-boot are synced. DT
> binding header files are synced separately as there is already one
> patch floating around. The DT sync also includes clean-up changes only
> recently posted, and likely won't make it in for at least a few weeks.
>
> Please have a look, and test if possible. I cc-ed a couple people that
> showed interest in this board on mailing lists recently.
>
Thank you for updating the dts for rk3328. I have Rock64 v2 and v3
boards and have tested your patchset with OpenBSD-current. The v2 board
is working and I have not noticed any regressions. The v3 board prior
to your patchset was not booting and continues to not boot.
U-Boot TPL 2020.04-rc3-00172-gaf827140e5-dirty (Mar 27 2020 - 09:44:24)
LPDDR3, 800MHz
BW=32 Col=11 Bk=8 CS0 Row=15 CS1 Row=15 CS=2 Die BW=16 Size=4096MB
Trying to boot from BOOTROM
Returning to boot ROM...
U-Boot SPL 2020.04-rc3-00172-gaf827140e5-dirty (Mar 27 2020 - 09:44:24 -0400)
Trying to boot from MMC1
Card did not respond to voltage select!
spl: mmc init failed with error: -95
Trying to boot from MMC2
Card did not respond to voltage select!
spl: mmc init failed with error: -95
SPL: failed to boot from all boot devices
### ERROR ### Please RESET the board ###
The Rock64 v3 board issues are unrelated to your patch set, but I
believe it needs a similar approach as?ROC-RK3328-CC. Here is some
info previously posted regarding this:
https://marc.info/?t=155751506500001&r=1&w=2
Regards,
-Kurt
> Regards
> ChenYu
>
>
> Chen-Yu Tsai (6):
> ? rockchip: dts: rk3328-evb: Move vcc5v0-host-xhci-drv to -u-boot.dtsi
> ? rockchip: dts: rk3328-evb: Move gmac2io related nodes to -u-boot.dtsi
> ? dt-bindings: clock: rk3328: sync from upstream Linux kernel
> ? dt-bindings: power: rk3328-power: sync from upstream Linux kernel
> ? rockchip: dts: rk3328: Sync device tree files from Linux
> ? rockchip: rk3328: Add support for ROC-RK3328-CC board
>
> ?arch/arm/dts/Makefile?????????????????????????|????1 +
> ?arch/arm/dts/rk3328-evb-u-boot.dtsi???????????|???39 +
> ?arch/arm/dts/rk3328-evb.dts???????????????????|??220 +--
> ?arch/arm/dts/rk3328-roc-cc-u-boot.dtsi????????|???17 +
> ?.../{rk3328-rock64.dts => rk3328-roc-cc.dts}??|??135 +-
> ?arch/arm/dts/rk3328-rock64.dts????????????????|??132 +-
> ?arch/arm/dts/rk3328.dtsi??????????????????????| 1420 +++++++++++------
> ?arch/arm/mach-rockchip/rk3328/Kconfig?????????|????8 +
> ?board/firefly/roc-cc-rk3328/Kconfig???????????|???24 +
> ?board/firefly/roc-cc-rk3328/MAINTAINERS???????|????7 +
> ?board/firefly/roc-cc-rk3328/Makefile??????????|????1 +
> ?board/firefly/roc-cc-rk3328/board.c???????????|???38 +
> ?configs/roc-cc-rk3328_defconfig???????????????|???97 ++
> ?doc/README.rockchip???????????????????????????|????4 +-
> ?include/dt-bindings/clock/rk3328-cru.h????????|??212 +--
> ?include/dt-bindings/power/rk3328-power.h??????|???19 +
> ?16 files changed, 1622 insertions(+), 752 deletions(-)
> ?create mode 100644 arch/arm/dts/rk3328-roc-cc-u-boot.dtsi
> ?copy arch/arm/dts/{rk3328-rock64.dts => rk3328-roc-cc.dts} (68%)
> ?create mode 100644 board/firefly/roc-cc-rk3328/Kconfig
> ?create mode 100644 board/firefly/roc-cc-rk3328/MAINTAINERS
> ?create mode 100644 board/firefly/roc-cc-rk3328/Makefile
> ?create mode 100644 board/firefly/roc-cc-rk3328/board.c
> ?create mode 100644 configs/roc-cc-rk3328_defconfig
> ?create mode 100644 include/dt-bindings/power/rk3328-power.h
>
next prev parent reply other threads:[~2020-03-27 15:07 UTC|newest]
Thread overview: 24+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-03-27 4:41 [PATCH 0/6] rockchip: rk3328: sync dts and add ROC-RK3328-CC board Chen-Yu Tsai
2020-03-27 4:41 ` [PATCH 1/6] rockchip: dts: rk3328-evb: Move vcc5v0-host-xhci-drv to -u-boot.dtsi Chen-Yu Tsai
2020-03-27 6:38 ` Kever Yang
2020-03-27 4:41 ` [PATCH 2/6] rockchip: dts: rk3328-evb: Move gmac2io related nodes " Chen-Yu Tsai
2020-03-27 6:38 ` Kever Yang
2020-03-27 4:41 ` [PATCH 3/6] dt-bindings: clock: rk3328: sync from upstream Linux kernel Chen-Yu Tsai
2020-03-27 6:39 ` Kever Yang
2020-03-27 4:41 ` [PATCH 4/6] dt-bindings: power: rk3328-power: " Chen-Yu Tsai
2020-03-27 6:39 ` Kever Yang
2020-03-27 4:41 ` [PATCH 5/6] rockchip: dts: rk3328: Sync device tree files from Linux Chen-Yu Tsai
2020-03-27 6:39 ` Kever Yang
2020-03-27 4:41 ` [PATCH 6/6] rockchip: rk3328: Add support for ROC-RK3328-CC board Chen-Yu Tsai
2020-03-27 6:41 ` Kever Yang
2020-03-30 17:44 ` Jagan Teki
2020-03-30 18:24 ` Chen-Yu Tsai
2020-03-31 10:57 ` Jagan Teki
2020-03-31 11:46 ` Chen-Yu Tsai
2020-03-31 12:37 ` Jagan Teki
2020-04-01 10:09 ` Chen-Yu Tsai
2020-04-01 19:15 ` Kurt Miller
2020-03-27 15:07 ` Kurt Miller [this message]
2020-03-27 17:44 ` [PATCH 0/6] rockchip: rk3328: sync dts and add " Chen-Yu Tsai
2020-03-27 22:03 ` Kurt Miller
2020-03-30 4:45 ` Chen-Yu Tsai
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1585321655.5148.23.camel@intricatesoftware.com \
--to=kurt@intricatesoftware.com \
--cc=u-boot@lists.denx.de \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox