From mboxrd@z Thu Jan 1 00:00:00 1970 From: Kurt Miller Date: Fri, 27 Mar 2020 11:07:35 -0400 Subject: [PATCH 0/6] rockchip: rk3328: sync dts and add ROC-RK3328-CC board In-Reply-To: <20200327044130.8763-1-wens@kernel.org> References: <20200327044130.8763-1-wens@kernel.org> Message-ID: <1585321655.5148.23.camel@intricatesoftware.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Fri, 2020-03-27 at 12:41 +0800, Chen-Yu Tsai wrote: > From: Chen-Yu Tsai > > Hi everyone, > > This series adds proper support for Firefly / Libre Computer ROC-RK3328-CC > single board computer. > > The ROC-RK3328-CC from Firefly and Libre Computer Project is a credit > card size development board based on the Rockchip RK3328 SoC, with: > > ? - 1/2/4 GB DDR4 DRAM > ? - eMMC connector for optional module > ? - micro SD card slot > ? - 1 x USB 3.0 host port > ? - 2 x USB 2.0 host port > ? - 1 x USB 2.0 OTG port > ? - HDMI video output > ? - TRRS connector with audio and composite video output > ? - gigabit Ethernet > ? - consumer IR receiver > ? - debug UART pins > > Originally I started with Loic's patches, and syncing the device tree > files from Linux. That didn't get very far, with SPL failing to detect > the SD card. Examining the schematics and internal state of GRF and > GPIOs, I realized that the logic for the SD card power enable switch > is opposite that of what the SD card controller's SDMMC0_PWREN pin > would use. Instead, directly using the GPIO is required. > > Thus this series creates a special target for this board to handle > muxing this specific pin to GPIO state. The GPIO is left in input mode, > letting the external pull-down work its magic. > > Along the way, there are some clean-ups of existing dts files, moving > U-boot only features to -u-boot.dtsi files, and then a wholesale sync > from Linux. Only boards already existing in U-boot are synced. DT > binding header files are synced separately as there is already one > patch floating around. The DT sync also includes clean-up changes only > recently posted, and likely won't make it in for at least a few weeks. > > Please have a look, and test if possible. I cc-ed a couple people that > showed interest in this board on mailing lists recently. > Thank you for updating the dts for rk3328. I have Rock64 v2 and v3 boards and have tested your patchset with OpenBSD-current. The v2 board is working and I have not noticed any regressions. The v3 board prior to your patchset was not booting and continues to not boot. U-Boot TPL 2020.04-rc3-00172-gaf827140e5-dirty (Mar 27 2020 - 09:44:24) LPDDR3, 800MHz BW=32 Col=11 Bk=8 CS0 Row=15 CS1 Row=15 CS=2 Die BW=16 Size=4096MB Trying to boot from BOOTROM Returning to boot ROM... U-Boot SPL 2020.04-rc3-00172-gaf827140e5-dirty (Mar 27 2020 - 09:44:24 -0400) Trying to boot from MMC1 Card did not respond to voltage select! spl: mmc init failed with error: -95 Trying to boot from MMC2 Card did not respond to voltage select! spl: mmc init failed with error: -95 SPL: failed to boot from all boot devices ### ERROR ### Please RESET the board ### The Rock64 v3 board issues are unrelated to your patch set, but I believe it needs a similar approach as?ROC-RK3328-CC. Here is some info previously posted regarding this: https://marc.info/?t=155751506500001&r=1&w=2 Regards, -Kurt > Regards > ChenYu > > > Chen-Yu Tsai (6): > ? rockchip: dts: rk3328-evb: Move vcc5v0-host-xhci-drv to -u-boot.dtsi > ? rockchip: dts: rk3328-evb: Move gmac2io related nodes to -u-boot.dtsi > ? dt-bindings: clock: rk3328: sync from upstream Linux kernel > ? dt-bindings: power: rk3328-power: sync from upstream Linux kernel > ? rockchip: dts: rk3328: Sync device tree files from Linux > ? rockchip: rk3328: Add support for ROC-RK3328-CC board > > ?arch/arm/dts/Makefile?????????????????????????|????1 + > ?arch/arm/dts/rk3328-evb-u-boot.dtsi???????????|???39 + > ?arch/arm/dts/rk3328-evb.dts???????????????????|??220 +-- > ?arch/arm/dts/rk3328-roc-cc-u-boot.dtsi????????|???17 + > ?.../{rk3328-rock64.dts => rk3328-roc-cc.dts}??|??135 +- > ?arch/arm/dts/rk3328-rock64.dts????????????????|??132 +- > ?arch/arm/dts/rk3328.dtsi??????????????????????| 1420 +++++++++++------ > ?arch/arm/mach-rockchip/rk3328/Kconfig?????????|????8 + > ?board/firefly/roc-cc-rk3328/Kconfig???????????|???24 + > ?board/firefly/roc-cc-rk3328/MAINTAINERS???????|????7 + > ?board/firefly/roc-cc-rk3328/Makefile??????????|????1 + > ?board/firefly/roc-cc-rk3328/board.c???????????|???38 + > ?configs/roc-cc-rk3328_defconfig???????????????|???97 ++ > ?doc/README.rockchip???????????????????????????|????4 +- > ?include/dt-bindings/clock/rk3328-cru.h????????|??212 +-- > ?include/dt-bindings/power/rk3328-power.h??????|???19 + > ?16 files changed, 1622 insertions(+), 752 deletions(-) > ?create mode 100644 arch/arm/dts/rk3328-roc-cc-u-boot.dtsi > ?copy arch/arm/dts/{rk3328-rock64.dts => rk3328-roc-cc.dts} (68%) > ?create mode 100644 board/firefly/roc-cc-rk3328/Kconfig > ?create mode 100644 board/firefly/roc-cc-rk3328/MAINTAINERS > ?create mode 100644 board/firefly/roc-cc-rk3328/Makefile > ?create mode 100644 board/firefly/roc-cc-rk3328/board.c > ?create mode 100644 configs/roc-cc-rk3328_defconfig > ?create mode 100644 include/dt-bindings/power/rk3328-power.h >