From: "Heiko Stübner" <heiko@sntech.de>
To: u-boot@lists.denx.de
Subject: [U-Boot] [PATCH v2 0/8] basic rockchip rk3188 support
Date: Thu, 28 Jul 2016 12:34:45 +0200 [thread overview]
Message-ID: <1684015.WIf6Idf9vd@diego> (raw)
In-Reply-To: <CAPnjgZ2hfcGODo20GdyyoU+j9_3S8D=+Wdb30+pOJW0bvTEMcw@mail.gmail.com>
Hi Simon,
Am Mittwoch, 27. Juli 2016, 21:42:47 schrieb Simon Glass:
> On 22 July 2016 at 15:51, Heiko Stuebner <heiko@sntech.de> wrote:
> > Second version. Simon already applied the cleanup patches from my
> > first version. I've tried to address Simons comments and hopefully
> > haven't overlooked any.
> >
> > SPL is still missing, so following Simons comment from earlier
> > it cannot go in yet, but maybe the first two cleanups can.
>
> Re the first patch, if you can resend it as a 'move' patch then I can
> apply it. Please base on u-boot-rockchip/master.
ok, I can do that :-)
> For rk3188, yes I would prefer to wait until we have the proper SPL.
> It sounds like you are close? I don't have an rk3188 board - I could
> get a TV box with that chip but I'm not sure if it would work for
> development.
I wouldn't call it close, but it's moving along somewhat and we figure out the
special requirements step by step. As for yout getting a box, I guess the
worst part is finding serial pin testpoints. For booting the rk3188 seems to be
the easiest of them all - if you plug in a suitably prepared card, it will
always prefer this one over everything else.
Heiko
> > changes in v2:
> > - move clock drivers to subdirectory
> > - use already available log2 function in clock drivers
> > - SPDX header in clock bindings
> > - showcase rk3188 arch code and rock board
> >
> > Heiko Stuebner (10):
> > rockchip: move clock drivers into a subdirectory
> > rockchip: remove log2 reimplementation from clock drivers
> > rockchip: rk3188: Add header files for PMU and GRF
> > rockchip: rk3188: Add pinctrl driver
> > rockchip: rk3188: Bring in rk3066/rk3188 clock bindings
> > rockchip: rk3188: Add clock driver
> > rockchip: rk3188: add core support
> > rockchip: rk3188: Radxa Rock board
> > add unfinished SPL support
> > hacks to make my rock netboot a fit image
> >
> > arch/arm/dts/Makefile | 1 +
> > arch/arm/dts/rk3188-radxarock.dts | 406 +++++++++++
> > arch/arm/dts/rk3188.dtsi | 631 ++++++++++++++++++
> > arch/arm/dts/rk3xxx.dtsi | 431 ++++++++++++
> > arch/arm/include/asm/arch-rockchip/cru_rk3188.h | 183 +++++
> > arch/arm/include/asm/arch-rockchip/grf_rk3188.h | 589 ++++++++++++++++
> > arch/arm/include/asm/arch-rockchip/pmu_rk3188.h | 36 +
> > arch/arm/mach-rockchip/Kconfig | 11 +
> > arch/arm/mach-rockchip/Makefile | 2 +
> > arch/arm/mach-rockchip/rk3188-board-spl.c | 190 ++++++
> > arch/arm/mach-rockchip/rk3188/Kconfig | 20 +
> > arch/arm/mach-rockchip/rk3188/Makefile | 10 +
> > arch/arm/mach-rockchip/rk3188/clk_rk3188.c | 17 +
> > arch/arm/mach-rockchip/rk3188/reset_rk3188.c | 47 ++
> > arch/arm/mach-rockchip/rk3188/sdram_rk3188.c | 839
> > +++++++++++++++++++++++ arch/arm/mach-rockchip/rk3188/syscon_rk3188.c
> > | 24 +
> > board/radxa/rock/Kconfig | 15 +
> > board/radxa/rock/MAINTAINERS | 6 +
> > board/radxa/rock/Makefile | 7 +
> > board/radxa/rock/rock.c | 32 +
> > configs/rock_defconfig | 80 +++
> > drivers/clk/Makefile | 3 +-
> > drivers/clk/clk_rk3036.c | 386 -----------
> > drivers/clk/clk_rk3288.c | 851
> > ------------------------ drivers/clk/rockchip/Makefile
> > | 9 +
> > drivers/clk/rockchip/clk_rk3036.c | 382 +++++++++++
> > drivers/clk/rockchip/clk_rk3188.c | 493 ++++++++++++++
> > drivers/clk/rockchip/clk_rk3288.c | 847
> > +++++++++++++++++++++++ drivers/pinctrl/Kconfig
> > | 9 +
> > drivers/pinctrl/rockchip/Makefile | 1 +
> > drivers/pinctrl/rockchip/pinctrl_rk3188.c | 613 +++++++++++++++++
> > drivers/usb/host/dwc2.c | 4 +-
> > include/configs/rk3188_common.h | 109 +++
> > include/configs/rock.h | 66 ++
> > include/dt-bindings/clock/rk3066a-cru.h | 32 +
> > include/dt-bindings/clock/rk3188-cru-common.h | 248 +++++++
> > include/dt-bindings/clock/rk3188-cru.h | 48 ++
> > tools/rkcommon.c | 1 +
> > 38 files changed, 6438 insertions(+), 1241 deletions(-)
> > create mode 100644 arch/arm/dts/rk3188-radxarock.dts
> > create mode 100644 arch/arm/dts/rk3188.dtsi
> > create mode 100644 arch/arm/dts/rk3xxx.dtsi
> > create mode 100644 arch/arm/include/asm/arch-rockchip/cru_rk3188.h
> > create mode 100644 arch/arm/include/asm/arch-rockchip/grf_rk3188.h
> > create mode 100644 arch/arm/include/asm/arch-rockchip/pmu_rk3188.h
> > create mode 100644 arch/arm/mach-rockchip/rk3188-board-spl.c
> > create mode 100644 arch/arm/mach-rockchip/rk3188/Kconfig
> > create mode 100644 arch/arm/mach-rockchip/rk3188/Makefile
> > create mode 100644 arch/arm/mach-rockchip/rk3188/clk_rk3188.c
> > create mode 100644 arch/arm/mach-rockchip/rk3188/reset_rk3188.c
> > create mode 100644 arch/arm/mach-rockchip/rk3188/sdram_rk3188.c
> > create mode 100644 arch/arm/mach-rockchip/rk3188/syscon_rk3188.c
> > create mode 100644 board/radxa/rock/Kconfig
> > create mode 100644 board/radxa/rock/MAINTAINERS
> > create mode 100644 board/radxa/rock/Makefile
> > create mode 100644 board/radxa/rock/rock.c
> > create mode 100644 configs/rock_defconfig
> > delete mode 100644 drivers/clk/clk_rk3036.c
> > delete mode 100644 drivers/clk/clk_rk3288.c
> > create mode 100644 drivers/clk/rockchip/Makefile
> > create mode 100644 drivers/clk/rockchip/clk_rk3036.c
> > create mode 100644 drivers/clk/rockchip/clk_rk3188.c
> > create mode 100644 drivers/clk/rockchip/clk_rk3288.c
> > create mode 100644 drivers/pinctrl/rockchip/pinctrl_rk3188.c
> > create mode 100644 include/configs/rk3188_common.h
> > create mode 100644 include/configs/rock.h
> > create mode 100644 include/dt-bindings/clock/rk3066a-cru.h
> > create mode 100644 include/dt-bindings/clock/rk3188-cru-common.h
> > create mode 100644 include/dt-bindings/clock/rk3188-cru.h
> >
> > --
> > 2.8.1
>
> Regards,
> Simon
prev parent reply other threads:[~2016-07-28 10:34 UTC|newest]
Thread overview: 18+ messages / expand[flat|nested] mbox.gz Atom feed top
2016-07-22 21:51 [U-Boot] [PATCH v2 0/8] basic rockchip rk3188 support Heiko Stuebner
2016-07-22 21:51 ` [U-Boot] [PATCH v2 1/8] rockchip: move clock drivers into a subdirectory Heiko Stuebner
2016-07-23 2:08 ` Simon Glass
2016-07-22 21:51 ` [U-Boot] [PATCH v2 2/8] rockchip: remove log2 reimplementation from clock drivers Heiko Stuebner
2016-07-23 2:08 ` Simon Glass
2016-07-22 21:51 ` [U-Boot] [PATCH v2 3/8] rockchip: rk3188: Add header files for PMU and GRF Heiko Stuebner
2016-07-22 21:51 ` [U-Boot] [PATCH v2 4/8] rockchip: rk3188: Add pinctrl driver Heiko Stuebner
2016-07-22 21:51 ` [U-Boot] [PATCH v2 5/8] rockchip: rk3188: Bring in rk3066/rk3188 clock bindings Heiko Stuebner
2016-07-23 2:08 ` Simon Glass
2016-07-22 21:51 ` [U-Boot] [PATCH v2 6/8] rockchip: rk3188: Add clock driver Heiko Stuebner
2016-07-23 2:08 ` Simon Glass
2016-07-22 21:51 ` [U-Boot] [PATCH v2 7/8] rockchip: rk3188: add core support Heiko Stuebner
2016-07-22 21:54 ` Heiko Stübner
2016-07-23 2:08 ` Simon Glass
2016-07-22 21:51 ` [U-Boot] [PATCH v2 8/8] rockchip: rk3188: Radxa Rock board Heiko Stuebner
2016-07-23 2:08 ` Simon Glass
2016-07-28 3:42 ` [U-Boot] [PATCH v2 0/8] basic rockchip rk3188 support Simon Glass
2016-07-28 10:34 ` Heiko Stübner [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1684015.WIf6Idf9vd@diego \
--to=heiko@sntech.de \
--cc=u-boot@lists.denx.de \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox