[U-Boot] [PATCH 01/13] mxc nand: Merge mtd and spl register definitions

["Benoît Thébaudeau" <benoit.thebaudeau@advansee.com>]

Hi Stefano,

> On 13/08/2012 22:48, Beno?t Th?baudeau wrote:
> > This patches fixes the TODO to use same register definitions in mtd
> > mxc_nand and
> > nand_spl fsl nfc drivers.
> > 
> > Signed-off-by: Beno?t Th?baudeau <benoit.thebaudeau@advansee.com>
> > Cc: Scott Wood <scottwood@freescale.com>
> > Cc: Stefano Babic <sbabic@denx.de>
> > ---
> 
> Hi Beno?t,
> 
> before going deeper in the review there is a general issue.
> 
> nand_spl was used in the past and it was the first implementation to
> have a first loader able to copy u-boot into RAM when the SOC boots
> from
> NAND. It is replaced by the general SPL framework. All new
> implementations must use the new SPL framework, What you see under
> nand_spl is referred to already supported boards.
> 
> With general SPL, we do not have two drivers for NAND, and we are
> able
> to boot from other devices, too. So it makes no sense to try to
> uniform
> the driver under nand_spl with the main driver, we want to use only
> the
> main driver.

Then, I don't know what to do with these patches.

Note that this is not a new implementation, but only an enhancement of the
existing one. But I understand your point.

I don't see any i.MX board using the general SPL for NAND. So we can't say that
it's usable with the current mtd mxc_nand driver in its current state. Moreover,
with the general SPL, I'd be very concerned as to the code size of mxc_nand (the
target size of the whole SPL code is only 2 kiB for current i.MX users of
nand_spl).

IMHO, we could improve and fix the nand_spl code while it's still there and
used. This does not prevent from moving to the general SPL once ready for
mxc_nand. These are two different topics.

Best regards,
Beno?t