Re: [PATCH v4 0/6] rpi5: initial support

[Stefan Agner <stefan@agner.ch>]

Hi Ivan,

Thanks for the quick response!

On 2024-09-19 11:52, Ivan T. Ivanov wrote:
> Hi Stefan,
> 
>> On 19 Sep 2024, at 12:36, Stefan Agner <stefan@agner.ch> wrote:
>> 
>> Hi Ivan,
>> 
>> I am looking into enabling NVMe boot support using U-Boot on Raspberry
>> Pi 5. Which brings me to some questions wrt PCIe support (see below).
>> 
>> On 2024-01-10 13:29, Ivan T. Ivanov wrote:
>>> 
> 
> 
>>> * I am dropping PCIe patch for now. I made some progress on porting changes
>>>  from vendor Linux tree to U-Boot. Unfortunatly testing it is little bit
>>>  tricky. They are many devices behind PCIe, but more or less all of them
>>>  requires missing either "reset-controller" or "clock-controller" or
>>>  "pin-controller" drivers. I was able to probe "cdns,macb" device, but
>>>  access to ethernet PHY over MDIO bus is stucking. Then I ported
>>>  "raspberrypi,rp1-adc" driver from vendor Linux tree, but it requires
>>>  missing clock. And on top of that machine that I used for developing this
>>>  crashed and I lost my PCIe changes :-|. Anyway.
>> 
>> Have you tried using a M.2 HAT? This likely won't require much in terms
>> of enabling the device.
>> 
>> You write that you made some progress, is that compared to v3? Do you
>> mind sharing the latest version of your patches?
> 
> 
> No further progress on PCIe for U-Boot from my side was made, sorry.
> 

So v3 the patch you've shared in v3 is your latest state? I was
wondering since you wrote in this v4 patch set "I made some progress on
porting changes
 from vendor Linux tree to U-Boot."...


> Stan is working on adding support for 2712 PCIe in Linux [1]. Perhaps
> once this is complete we can work on adding U-Boot support for the same,
> unless someone don’t beat us, of course. 

Hm, it seems the link did not make it. I guess you meant to link this
patch set [1]

--
Stefan

[1]
https://lore.kernel.org/lkml/20240910151845.17308-1-svarbanov@suse.de/T/

> 
> Regards,
> Ivan