Re: [PATCH 0/5] mx6cuboxi: add eth support for SoMs revision 1.9+

[Josua Mayer <josua@solid-run.com>]

Greetings everybody,

The changes to the adin phy device-tree bindings and driver have been 
applied to netdev/net-next:
https://patchwork.kernel.org/project/netdevbpf/cover/20220517085143.3749-1-josua@solid-run.com/

As there have been no further comments, I will send v2 soon including 
some changes the Linux maintainers asked for - and drop the first patch 
now that Nate Drude has submitted a fix:
phy: adin: fix broken support for adi,phy-mode-override

sincerely
Josua Mayer

Am 01.05.22 um 15:41 schrieb Josua Mayer:
> As of Revision 1.9 the SolidRun i.MX6 SoMs ship with a new PHY - an
> ADIN1300 at address 1. This patchset carries many small parts to
> facilitate proper operation of the ethernet port in U-Boot as well as
> Linux:
> 
> 1. Fix a compile error in the recently phy driver
> 2. Add support for configuring the clock output pins to the phy driver
> 3. update device-tree with support for the neew phy
> 4. support runtime patching of device-tree for Linux:
>     enables only the phy node detected during boot, to avoid
>     warning messages during boot.
> 5. finally enable the phy driver in the cuboxi defconfig
> 
> Josua Mayer (5):
>    phy: adin: remove broken support for adi,phy-mode-override
>    phy: adin: add support for clock output
>    ARM: dts: imx6qdl-sr-som: add support for alternate phy addresses
>    mx6cuboxi: fixup dtb ethernet phy nodes before booting an OS
>    mx6cuboxi: enable driver for adin1300 phy
> 
>   arch/arm/dts/imx6qdl-sr-som.dtsi     | 17 +++++-
>   board/solidrun/mx6cuboxi/mx6cuboxi.c | 78 +++++++++++++++++++++++++++
>   configs/mx6cuboxi_defconfig          |  2 +
>   drivers/net/phy/adin.c               | 80 ++++++++++++++++------------
>   4 files changed, 141 insertions(+), 36 deletions(-)
>