[U-Boot-Users] MPC8266 Abatron config file

[U-Boot-Users] MPC8266 Abatron config file

[Allen Curtis]

Does anyone have a configuration file which works with u=boot?  I have a file 
which is good enough to communicate with the board and program the flash. 
However when I try to run u-boot (type go), the baud rate is not correct. It 
appears that it is 4X the configured rate. If I remove the Abatron and boot 
normally, everything works fine.

TIA

-- 
All things come to those who wait. Some of us just have to wait a little 
longer...

[U-Boot-Users] MPC8266 Abatron config file

[Wolfgang Denk]

In message <200312021130.26182.acurtis@onz.com> you wrote:
> Does anyone have a configuration file which works with u=boot?  I have a file 
> which is good enough to communicate with the board and program the flash. 
> However when I try to run u-boot (type go), the baud rate is not correct. It 
> appears that it is 4X the configured rate. If I remove the Abatron and boot 
> normally, everything works fine.

Well, this is a setting which is definitely hardware  (board)  depen-
dend.  So  if you don't give away any facts about your hardware it is
impossible to help (actually it's probably impossible in  general  as
this might be a custom board).


Best regards,

Wolfgang Denk

-- 
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd at denx.de
Every program has at least one bug and can be shortened by  at  least
one instruction - from which, by induction, one can deduce that every
program can be reduced to one instruction which doesn't work.

[U-Boot-Users] MPC8266 Abatron config file

[Allen Curtis]

This is a standard ADS8266 board. The MPC8266 configuration file I am using 
has been posted to this list, although I do not see it on your FTP site. 
Essentially it is the same at the MPC8260 version that is on the site.

On Tuesday 02 December 2003 12:13 pm, Wolfgang Denk wrote:
> In message <200312021130.26182.acurtis@onz.com> you wrote:
> > Does anyone have a configuration file which works with u=boot?  I have a
> > file which is good enough to communicate with the board and program the
> > flash. However when I try to run u-boot (type go), the baud rate is not
> > correct. It appears that it is 4X the configured rate. If I remove the
> > Abatron and boot normally, everything works fine.
>
> Well, this is a setting which is definitely hardware  (board)  depen-
> dend.  So  if you don't give away any facts about your hardware it is
> impossible to help (actually it's probably impossible in  general  as
> this might be a custom board).
>
>
> Best regards,
>
> Wolfgang Denk

-- 
All things come to those who wait. Some of us just have to wait a little 
longer...