From mboxrd@z Thu Jan 1 00:00:00 1970 From: Allen Curtis Date: Tue, 2 Dec 2003 18:23:58 -0800 Subject: [U-Boot-Users] MPC8266 Abatron config file In-Reply-To: <20031202201359.8AF13C5F5F@atlas.denx.de> References: <20031202201359.8AF13C5F5F@atlas.denx.de> Message-ID: <200312021823.58512.acurtis@onz.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de This is a standard ADS8266 board. The MPC8266 configuration file I am using has been posted to this list, although I do not see it on your FTP site. Essentially it is the same at the MPC8260 version that is on the site. On Tuesday 02 December 2003 12:13 pm, Wolfgang Denk wrote: > In message <200312021130.26182.acurtis@onz.com> you wrote: > > Does anyone have a configuration file which works with u=boot? I have a > > file which is good enough to communicate with the board and program the > > flash. However when I try to run u-boot (type go), the baud rate is not > > correct. It appears that it is 4X the configured rate. If I remove the > > Abatron and boot normally, everything works fine. > > Well, this is a setting which is definitely hardware (board) depen- > dend. So if you don't give away any facts about your hardware it is > impossible to help (actually it's probably impossible in general as > this might be a custom board). > > > Best regards, > > Wolfgang Denk -- All things come to those who wait. Some of us just have to wait a little longer...