[U-Boot-Users] AMCC Yellowstone board update

[U-Boot-Users] AMCC Yellowstone board update

[Steven Blakeslee]

Attached is a patch to update the support for the AMCC Yellowstone
board.  It does the following.
 
1.  Enable the PCI interrupt.  I submitted a patch previously that did
this same thing.
2.  Disable the FLASH write protect in the board control and status
registers.
3.  Added a function to dynamically figure a value for the
SDRAM0_TR1[RDCT].  This value needs to be adjusted on each boot and any
440 designs with DDR should do this.
-------------- next part --------------
A non-text attachment was scrubbed...
Name: yellowstone-patch
Type: application/octet-stream
Size: 6268 bytes
Desc: yellowstone-patch
Url : http://lists.denx.de/pipermail/u-boot/attachments/20051108/76586c0c/attachment.obj 

[U-Boot-Users] AMCC Yellowstone board update

[Stefan Roese]

Hi Steve,

On Tuesday 08 November 2005 17:52, Steven Blakeslee wrote:
> Attached is a patch to update the support for the AMCC Yellowstone
> board.  It does the following.
>
> 1.  Enable the PCI interrupt.  I submitted a patch previously that did
> this same thing.

As you may have noticed, we recently added not only PCI interrupt support, but 
configured all ext. IRQ's. Is there any reason to only setup the PCI IRQ?

Please take a look at the currect U-Boot CVS/GIT version and let me know, if 
this is ok.

> 2.  Disable the FLASH write protect in the board control and status
> registers.
> 3.  Added a function to dynamically figure a value for the
> SDRAM0_TR1[RDCT].  This value needs to be adjusted on each boot and any
> 440 designs with DDR should do this.

Could you please resubmit your patch against the currect CVS/GIT version. And 
please also send a CHANGELOG entry. Also for yosemite of course.

Best regards,
Stefan