[U-Boot-Users] lite5200b board - Serial download of image

[U-Boot-Users] lite5200b board - Serial download of image

[Sri]

Hi 

I tried to download image through serial via Kermit 

Using commands:  

send /bin /tftpboot/uImage  at Kermit prompt

&          

Uboot command:           loadb address 

 

Retransmission count exceeds in Kermit and transmission of packet fails.

And, on u-boot side only 0 Bytes are received.

 

What might be the issue?

 

Thanks,

kala.

 



DISCLAIMER:
-----------------------------------------------------------------------------------------------------------------------

The contents of this e-mail and any attachment(s) are confidential and intended for the named recipient(s) only.
It shall not attach any liability on the originator or HCL or its affiliates. Any views or opinions presented in 
this email are solely those of the author and may not necessarily reflect the opinions of HCL or its affiliates.
Any form of reproduction, dissemination, copying, disclosure, modification, distribution and / or publication of 
this message without the prior written consent of the author of this e-mail is strictly prohibited. If you have 
received this email in error please delete it and notify the sender immediately. Before opening any mail and 
attachments please check them for viruses and defect.

-----------------------------------------------------------------------------------------------------------------------
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.denx.de/pipermail/u-boot/attachments/20070816/6bbd179c/attachment.htm 

[U-Boot-Users] lite5200b board - Serial download of image

[Wolfgang Denk]

Heln message <66E8AEE9980BB44CA5FCAD39EBA56AC60214AA3B@CHN-HCLT-EVS02.HCLT.CORP.HCL.IN> you wrote:
> 
> I tried to download image through serial via Kermit 
> Using commands:  
> send /bin /tftpboot/uImage  at Kermit prompt
> &          
> Uboot command:           loadb address 
> 
> Retransmission count exceeds in Kermit and transmission of packet fails.
> And, on u-boot side only 0 Bytes are received.
> What might be the issue?

You may have forgotten to set the correct parameters in kermit. See
the example .kermrc file in the U-Boot manual at
http://www.denx.de/wiki/view/DULG/SystemSetup#Section_4.3.

> The contents of this e-mail and any attachment(s) are confidential and>  intended for the named recipient(s) only.
> It shall not attach any liability on the originator or HCL or its>  affiliates. Any views or opinions presented in 
> this email are solely those of the author and may not necessarily reflect>  the opinions of HCL or its affiliates.
...

Please omit this when posting to public mailing lists,


> ------_=_NextPart_001_01C7DFCC.3F3A3C3F
> Content-Type: text/html;
> 	charset="us-ascii"
> Content-Transfer-Encoding: quoted-printable

And NEVER post HTML here!

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"The good Christian should beware of mathematicians and all those who
make empty prophecies. The danger already exists that  mathematicians
have  made a covenant with the devil to darken the spirit and confine
man in the bonds of Hell."                          - Saint Augustine