[U-Boot-Users] [PATCH] ARM: add support of CONFIG_LAST_STAGE_INIT for arm

[Wolfgang Denk <wd@denx.de>]

In message <200712111205.48970.vapier@gentoo.org> you wrote:
>
> > Please keep in mind that U-Boot shall initialize hardware if and only
> > if it is using it (and that it must deactivate it after use).
> 
> with many pieces of hardware, you can draw a line between initializing it and 
> actually enabling/using it.

Correct. If make such a difference, then initialization shall be
performed when you enable it for the very first time in U-Boot.

There is many reasons for such a design; for example, think about the
system boot time.

> for example, shouldnt the initialization/programming of the MAC address always 
> happen regardless of the network being used ?  not all MAC's have/support 

Not, it should not. It must not.

> eeprom's which contain the MAC address, so the implicit address programming
> that happens in hardware cannot happen.

The MAC is not needed before you access the Ethernet  port,  so  ther
eis  no need to do it before - or to ever do it, if you don't use the
network in U-Boot.

Please see also the FAQ. 

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
My play was a complete success.  The audience was a failure.