[U-Boot-Users] [PATCH] ARM: add support of CONFIG_LAST_STAGE_INIT for arm

[Wolfgang Denk <wd@denx.de>]

In message <475ED93E.2070407@discworld.dascon.de> you wrote:
> Haavard Skinnemoen wrote:
> > It should probably initialize the PHY interface (i.e. the MDIO
> > interface) early, but I agree that it should delay initializing the
> > actual PHY until it is needed.
> >   
> That may depend on board/PHY: on some PHYs, the LED pin functions need 
> to be set in software, so on power-up the ethernet LEDs may light up and 
> display bogus states, so I would prefer to configure that early, even if 
> the port is not used.

I think that things like this should be done in board specific init
code, then.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Is not that the nature of men and women -- that the  pleasure  is  in
the learning of each other?
	-- Natira, the High Priestess of Yonada, "For the World is
	   Hollow and I Have Touched the Sky", stardate 5476.3.