[U-Boot-Users] 4xx ethernet bringup

[Stefan Roese <sr@denx.de>]

On Wednesday 19 December 2007, shami Allam wrote:
> I am working on the 405GP custome board. I am able to bringup the
> SDRAM,Flash,I2c and serail on the board. But while trying to bringup the
> ethernet i am getting the following error. "No Ethernet found". On my board
> there is "DP83848I" PHY chip.

This message gets printed when you don't define the "ethaddr" environement 
address. So set this variable to a valid value and save the environment and 
reset the board. Then you should see one eth-interface.

Best regards,
Stefan

=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================