From mboxrd@z Thu Jan  1 00:00:00 1970
From: Stefan Roese <sr@denx.de>
Date: Sat, 22 Dec 2007 12:27:56 +0100
Subject: [U-Boot-Users] 4xx ethernet bringup
In-Reply-To: <235873.32097.qm@web94114.mail.in2.yahoo.com>
References: <235873.32097.qm@web94114.mail.in2.yahoo.com>
Message-ID: <200712221227.56226.sr@denx.de>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

On Saturday 22 December 2007, shami Allam wrote:
> After booting my target i get the following message..
>
>  I2C:ready
>  DRAM:16MB
>  FLASH:2MB
>  In: serial
>  Out:serial
>  Err:serial
>  Net: ppc_4xx_eth0
>  =>
>  and after that if i say
>  => mii info
>  PHY 0x01: OUI = 0x80017, Model = 0x09, Rev = 0x00, 10baseT, HDX

And is this correct? Do you have a 10MBit connection?

>  => setenv ipaddr 192.168.13.248
>  => ping 192.168.13.248

So you try to ping to yourself here. This does not work. You have to ping to a 
different target (PC).

>  After this if i ping it's not pinging self and also the host
> ip(192.168.13.240). Can you help me out what could be the problem..... =>
> mii read 0x01<PHY Addr> 0x01<register val>
>  when i read the PHY 0x01 register following is the value 0x7849. This
> value show that "No Link". why so. PHY chip i am using DP83848I

Possibly a PHY configuartion problem. Did you check if you soldered the 
correct resistors and condensators? Is the power-supply ok?

Best regards,
Stefan

=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================