[U-Boot-Users] 4xx ethernet bringup

[Stefan Roese <sr@denx.de>]

On Saturday 22 December 2007, shami Allam wrote:
> > After this if i ping it's not pinging self and also the host
> > ip(192.168.13.240). Can you help me out what could be the problem..... =>
> > mii read 0x01
>
>  0x01
>
> > when i read the PHY 0x01 register following is the value 0x7849. This
> > value show that "No Link". why so. PHY chip i am using DP83848I
>
> Possibly a PHY configuartion problem. Did you check if you soldered the
> correct resistors and condensators? Is the power-supply ok?
>
>   if I do the PHY loopback by enabling the bit 14bit in the BMCR. i am
> getting the reply. Still you suspect PHY configuration problem.....or do i
> need to do anything at MAC side......

Yes, I still suspect PHY hardware problems. Check (again) all R's and C's, 
clocks and power supplies.

Best regards,
Stefan

=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================