[U-Boot-Users] NAND driver question

[Stefan Roese <sr@denx.de>]

On Tuesday 29 January 2008, Craig Millen wrote:
> I have been experiencing a few problems when using a NAND flash for
> storage in u-boot.
>
> When I'm reading large files (7MB) from the NAND, periodically there
> will be a NAND ECC read error when using the following command:
>
> => nand read 400000 0 154000
> NAND read: device 0 offset 0x0, size 0x154000  1392640 bytes read:
> ERROR.
>
> After turning on debug, the problem is occurring in the nand_read_ecc
> function whereby the ecc check fails. After running it numerous times,
> there seems to be no correlation between pages that fail and appears to
> be completely random.
> Has anyone else had these problems?

No. NAND blocks can fail and generate ECC errors. But your description doesn't 
really sound like this is a NAND chips related problem. Does this happen on 
multiple boards or just s single one? This looks more like a timing problem 
or something like this to me.

IIRC, then you had to change the 4xx NDFC driver to access the NAND via 8bit 
access, correct? I have used this driver on multiple 4xx boards and on all 
boards this driver can be used as is, meaning with 32bit access enabled. 
Perhaps you still have a problem with the interface to the NAND chips.

> Furthermore, the "nand write" command doesn't skip bad blocks.  Are you
> supposed to use a different command to write files to the NAND that
> skips the bad blocks?

As already mentioned the .jffs2" extension is what you want. ".i" for "image" 
should do too.

Best regards,
Stefan

=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================