[U-Boot-Users] U-boot Bus Fault Error while accessing NOR flash

[Stefan Roese <sr@denx.de>]

On Tuesday 19 February 2008, Nikhil Gautam wrote:
> Thanks for the information. My problem is that "md 0xFFFFE000" and any
> other read command up to this address works fine. Its just when I try
> to read @ 0xFFFF F000 I see this problem.

This problem with accessing the last 4k after NAND booting looks like a 
problem with either cache or TLB setup to me. Please keep in mind, that while 
booting via NAND the IPL (initial program loader) included in the PPC loads 
exactly 4k of code into the i-cache at the last 4k. So this is exactly your 
faulting location.

Note: I have not seen such issues with the NAND booting 4xx board I tested on 
so far.

Best regards,
Stefan

=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================