[U-Boot-Users] U-boot Bus Fault Error while accessing NOR flash

[Stefan Roese <sr@denx.de>]

Hi Nikhil,

On Wednesday 20 February 2008, Nikhil Gautam wrote:
> Below is the most of my init.S file. You are correct about the
> faulting location. But I can see in the init.S file that this address
> location is defined as "AC_R|AC_W|AC_X|SA_G" so I think I should be
> able to at least read it. When I boot from 256Mb NAND flash, I don't
> see this problem. Its only when I boot from 1Gb NAND flash.

Did you get this problem fixed on your board? If yes, what was it?

I'm asking because I'm currently adding 2k page size NAND device support to 
nand_spl and I'm seeing some strange exception on my target after running 
from SDRAM.

Thanks.

Best regards,
Stefan

=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================