[U-Boot-Users] U-boot Bus Fault Error while accessing NOR flash

[Stefan Roese <sr@denx.de>]

On Tuesday 08 April 2008, Stefan Roese wrote:
> > Below is the most of my init.S file. You are correct about the
> > faulting location. But I can see in the init.S file that this address
> > location is defined as "AC_R|AC_W|AC_X|SA_G" so I think I should be
> > able to at least read it. When I boot from 256Mb NAND flash, I don't
> > see this problem. Its only when I boot from 1Gb NAND flash.
>
> Did you get this problem fixed on your board? If yes, what was it?
>
> I'm asking because I'm currently adding 2k page size NAND device support to
> nand_spl and I'm seeing some strange exception on my target after running
> from SDRAM.

Never mind. I found my problem. One size was set incorrectly. Now I can boot 
successfully from 2k page size NAND devices. Patch for review will follow 
soon.

Best regards,
Stefan

=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================