[U-Boot-Users] [PATCH] PPC440 Power Management Registers

[Stefan Roese <sr@denx.de>]

Hi Eugene,

On Thursday 10 April 2008, Eugene O'Brien wrote:
> Here is an updated patch correcting only the pre-existing power
> management register definitions. (I might add that these definitions are
> not currently used in the U-Boot source tree either.)
>
> CHANGELOG:
>
> ppc440: Fix power mgt definitions for PPC440
>
> Corrected DCR addresses of PPC440 power management registers.
> All AMCC PPC440 processors conform to the same DCR address usage for
> these registers.
>
> Signed-off-by: Eugene O'Brien <eugene.obrien@advantechamt.com>

Unfortunately now your patch is line wrapped. And even if it wasn't line 
wrapped, it couldn't be applied using git-am (which makes life so much easier 
for me) because of the lines above and below the real patch.

I there a chance that you can create this patch by using git-format-patch? I 
know it is a lot of work for such a small patch, but once you've got all this 
git patch stuff working, you can send patches much easier in the future.

Thanks.

Best regards,
Stefan

=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================