[U-Boot-Users] Using uec.c and uec_phy.c

[U-Boot-Users] Using uec.c and uec_phy.c

[klibusel]

Hi,

I am using the polled uboot ethernet driver on
MPC8360erdk. I have trouble sending and receiving
ethernet packets. I  have configured the interface as
a generic MII and it detects the linking coming up.
However when the QUICC engine reads TXBD and indicates
TX is complete, nothing comes on the wire. This I
confirmed using ethereal. Also on the RX side if
connected to a PC I get RX error. I have made no
changes to the orginial code. The interface is a
BCM5481 on the board.

Any pointer will be appreciated.

Sampath

[U-Boot-Users] Using uec.c and uec_phy.c

[Kim Phillips]

On Sat, 10 May 2008 04:24:08 -0700 (PDT)
klibusel <klibusel@yahoo.com> wrote:

> Hi,
> 
> I am using the polled uboot ethernet driver on
> MPC8360erdk. I have trouble sending and receiving
> ethernet packets. I  have configured the interface as
> a generic MII and it detects the linking coming up.
> However when the QUICC engine reads TXBD and indicates
> TX is complete, nothing comes on the wire. This I
> confirmed using ethereal. Also on the RX side if
> connected to a PC I get RX error. I have made no
> changes to the orginial code. The interface is a
> BCM5481 on the board.
> 
> Any pointer will be appreciated.

you don't mention what version u-boot you're using; can you let us know
if the problem exists on Wolfgang's top of git tree (currently
v1.3.3-rc3-51-g65dcfa7)?

Kim