[U-Boot-Users] U-BOOT V2 MX27 boot problem

[U-Boot-Users] U-BOOT V2 MX27 boot problem

[yanjun.luo]

Hi,
I check out the last U-BOOT V2 code from git yesterday, 
and start to debug with my new MX27 board, just like MX27ADS.
I config the U-BOOT V2 with pcm038 configuration.

I use ADSToolKit Standard V1.3 from freescale to program
the bootloader. When I download redboot's binary file, it works.
But the U-BOOT binary, it can't work at all.

I checked the code and find that redboot TEXT BASE is 0xa7f00000,
but U-BOOT is 0xa0000000. I changed U-BOOT to use 0xa7f00000,
it can start some steps. I found it crashed at 
get_mtab-entry_by_path at fs.c

It seems that mtab is not correct, so e-path  never equal with path.

what's wrong with this? I still try to find what's wrong with mtab.

Any kind of hints are welcome.

Regards,
Yanjun Luo.

Below is boot message.

U-Boot 2.0.0-rc5-git (May 14 2008 - 15:01:09)

Board: Phytec phyCORE-i.MX27
cfi_probe: cfi_flash base: 0xc0000000 size: 0x02000000

mpll:     199499695 Hz
spll:     239999725 Hz
arm:      199499695 Hz
perclk1:   14777755 Hz
perclk2:   13299979 Hz
perclk3:   33249949 Hz
perclk4:   13299979 Hz
clkin26:   26000000 Hz
ahb:       66499898 Hz
ipg:       33249949 Hz
Malloc Space: 0xa7b00000 -> 0xa7f00000 (size  4 MB)