[U-Boot-Users] Strange behavior in UPM

[Anton Vorontsov <avorontsov@ru.mvista.com>]

On Fri, Jul 25, 2008 at 01:50:41PM -0300, Alemao wrote:
> Hi all,
> 
> I have a board based on the MPC8360E-RDK, and im trying to
> make NAND at local bus works with UPM. I put the scope to
> see what was going wrong and I got this:
> 
> 
>                      ___
> - the waveform in LGPL1/3 (nand CLE/ALE) should be  ___|     |___
>                   ___    ___
>   but was        |__|

The ascii art attempt failed. ;-)

[...]
> One detail, im using u-boot-1.1.4 and i got the codes for UPM and NAND
> from u-boot-1.3.4-rc1.

Since the boards are pretty the same, I guess you can just compile
the u-boot-1.3.3 (please try release instead of -rc, to be sure),
and see if NAND will work. Maybe it will need really small code
modifications for your board though.

Otherwise it is hard to say where is problem is (maybe the problem in
the 1.1.4 nand core code, not in UPM setup?).

Also, you didn't mention what kind of chip the board is using.

Thanks,

-- 
Anton Vorontsov
email: cbouatmailru at gmail.com
irc://irc.freenode.net/bd2