[U-Boot] [U-Boot-Users] [PATCH 1/4][RFC] Add initial high speed support to USB code.

["Markus Klotzbücher" <mk@denx.de>]

Hi Tor,

On Thu, Jul 10, 2008 at 05:22:18PM +0200, Tor Krill wrote:
> On 7/10/2008, "Markus Klotzb?cher" <mk@denx.de> wrote:
> >Tor Krill <tor@excito.com> writes:
> >
> >> Add high speed support to USB code. Extracted from Juniper Networks patch.
> >>
> >> I know that the mergewindow is closed but wanted to get feedback on these
> >> patches if possible.
> >
> >Thanks again for fixing this up. AFAIK patches look fine, only two
> > things:
> >
> >- please address the issues pointed out by Michael, especially removal
> >  of the "C" macro.
> >
> >- Secondly it would be nice if we could have a short README.ehci or
> >  similar which explains what works and what not, and what needs to be
> >  done to add further board/HC support.
> >
> >Thank you in advance.
> 
> Thank you for reviewing. I will try fix things up and resubmit
> later.

Any news about this? I'd very much like to get your patches merged...

Best regards
Markus Klotzb?cher

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de")