[U-Boot] [PATCH v3 0/6] i.MX31: Add NAND support and new PDK board.

[Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>]

On 22:02 Wed 03 Sep     , Magnus Lilja wrote:
> Hi,
> 
> 2008/8/29 Magnus Lilja <lilja.magnus@gmail.com>:
> > Hi again
> >
> > This series of patches adds support for the NAND flash controller in the
> > i.MX31 device and also introduces the Freescale i.MX31 PDK board.
> >
> > Changes since v2:
> >
> > - Added doc/README.mx31 (contains MC13783 SPI config documentation)
> > - Split the PDK patch into two patches, the first introduces the
> > board without NAND support, the second adds NAND support.
> > - Re-ordered the series so the NAND patches are placed last
> > - mx31_nand.c has been updated w.r.t. coding style.
> > - There are still issues with the NAND driver (i.e. not all comments from
> > Scott Wood have been taken care of yet). Therefore I suspect that the
> > NAND driver is not ready for inclusion yet, the other patches should be
> > OK.
> >
> > The patches are based on the current main U-boot git repo (as of
> > Friday morning).
> 
> 
> Is there are chance that the first couple of patches in the series can
> be merged into the official tree? I'm talking about the following
> patches:
> [PATCH v3 1/6] i.MX31: Add reset_timer() and modify get_timer_masked().
yes
> [PATCH v3 2/6] i.MX31: Make the SPI bus and chip select configurable for MC13783
yes
> [PATCH v3 3/6] i.MX31: Add basic support for Freescale's i.MX31 PDK board.
It will be apply in arm test branch until it can boot with flash

Best Regards,
J.