[U-Boot] [PATCH] [OneNAND] bad block aware read/write support

[Stefan Roese <sr@denx.de>]

On Thursday 06 November 2008, Kyungmin Park wrote:
> >> > +           ret = mtd->read_oob(mtd, ofs, &ops);
> >> > +           if (ret) {
> >> > +                   printk("Read failed 0x%x, %d", (unsigned int) ofs,
> >> > ret); +                   mtd->block_markbad(mtd, ofs);
> >
> > You are marking all blocks as bad whenever a failure occurs. I'm not sure
> > if we really should do it this way. Failures could have other reasons as
> > well. I'm inclined to remove this marking in my patch version.
> >
> > Any comments?
>
> Right, current implementation make a bad on all errors, but actually
> it need to try again in case read/write error. It will patch it later.

OK, I'll remove this bad block marking for now.

> > <snip>
> >
> >> I'm currently working on a version of this "bad block aware" OneNAND
> >> command support which resembles the NAND command style even more. I hope
> >> to have something ready till tomorrow that I can send to the list for
> >> review. I would really like to see some comments from you on this since
> >> you are much more experienced with the OneNAND stuff.
> >
> > Do you already have some comments to the patch version I posted
> > yesterday?
>
> Looks good to me. No problem to commit your version.
>
> Acked-by: Kyungmin Park <kyungmin.park@samsung.com>

Thanks. I'll send an updated version today or tomorrow.

Best regards,
Stefan

=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================