[U-Boot] [PATCH-OMAP3] OMAP3: Clean up EVM board file

[Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>]

On 23:38 Thu 20 Nov     , Jean-Christophe PLAGNIOL-VILLARD wrote:
> On 21:29 Sat 15 Nov     , dirk.behme at googlemail.com wrote:
> > - Use readx/writex instead of direct pointer access
> > - Replace hardcoded values by macros
> > - Minor space to tab conversion
> > 
> > Notes:
> > 
> > - Instead of read/modify/write GPIO_DATAOUT register use SET/CLEARDATAOUT
> >   register for GPIO64
> > - GPIO 1-6 CM_FCLKEN_PER and CM_ICLKEN_PER are already configured in
> >   per_clocks_enable(), remove it here
> > - Remove pin mux. Is done in set_muxconf_regs.
> > 
> > No functional change.
> > 
> > Signed-off-by: Dirk Behme <dirk.behme@gmail.com>
> > 
> > ---
> >  board/omap3/evm/evm.c              |  143 +++++++++----------------------------
> >  board/omap3/evm/evm.h              |   64 ++++++++--------
> >  include/asm-arm/arch-omap3/cpu.h   |    2 
> >  include/asm-arm/arch-omap3/mem.h   |    8 ++
> >  include/asm-arm/arch-omap3/omap3.h |    1 
> >  5 files changed, 78 insertions(+), 140 deletions(-)
> apply to u-boot-arm/omap3

please not that I've to remove the modification of
include/asm-arm/arch-omap3/omap3.h which does not apply

please send an incremental patch and please number them to known the order to
apply them

Best Regards,
J.