[U-Boot] [PATCH] ARM: add IDE init to lib_arm/board.c Part 1/1

[Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>]

On 14:10 Wed 17 Dec     , michael wrote:
> michael wrote:
> > Stefan Althoefer wrote:
> >   
> >> Jean-Christophe PLAGNIOL-VILLARD schrieb:
> >>
> >>   
> >>     
> >>>> diff -uprN u-boot-orig//lib_arm/board.c u-boot/lib_arm/board.c
> >>>> --- u-boot-orig//lib_arm/board.c	2008-12-02 17:25:32.000000000 +0100
> >>>> +++ u-boot/lib_arm/board.c	2008-12-02 23:29:36.000000000 +0100
> >>>> @@ -441,6 +441,11 @@ extern void davinci_eth_set_mac_addr (co
> >>>>  	}
> >>>>  #endif
> >>>>  
> >>>> +#if defined(CONFIG_CMD_IDE)
> >>>> +        puts("IDE:   ");
> >>>> +        ide_init();
> >>>> +#endif /* CONFIG_CMD_IDE */
> >>>>       
> >>>>         
> >>> are you sure it will work?
> >>>
> >>> Best Regards,
> >>> J.
> >>>     
> >>>       
> >> On my board (Janz emPC-A400 with IXP425) it does. With some more
> >> patches to add IDE to this board.
> >>
> >> What is your doubt?
> >>
> >> If you see problems, drop this. I can also add IDE to board_late_init().
> >>   
> >>     
> > I don't sure if the outsw/insw are implemented in arm.
> >
> > Regards Michael
> > _______________________________________________
> > U-Boot mailing list
> > U-Boot at lists.denx.de
> > http://lists.denx.de/mailman/listinfo/u-boot
> >
> >   
> Well, I'm not sure :( if the outsw/insw are implemented in arm.
IIRC they are not. I'll check but in u-boot we do not have the asm
implementtion.

Best Regards,
J.