[U-Boot] [PATCH V2] ppc4xx: Enable auto RS485 mode on PLU405 boards

[Matthias Fuchs <matthias.fuchs@esd-electronics.com>]

2nd version of this patch eliminates a whitespace issue :-(

This patch turns on the auto RS485 mode in the 2nd external
uart on PLU405 boards. This is a special mode of the used
Exar XR16C2850 uart. Because these boards only have a 485 physical
layer connected it's a good idea to turn it on by default.

Signed-off-by: Matthias Fuchs <mf@esd.eu>
---
 board/esd/plu405/plu405.c |   10 ++++++++++
 1 files changed, 10 insertions(+), 0 deletions(-)

diff --git a/board/esd/plu405/plu405.c b/board/esd/plu405/plu405.c
index 61186a8..85057a2 100644
--- a/board/esd/plu405/plu405.c
+++ b/board/esd/plu405/plu405.c
@@ -104,6 +104,7 @@ int misc_init_r (void)
 	unsigned char *duart0_mcr = (unsigned char *)((ulong)DUART0_BA + 4);
 	unsigned char *duart1_mcr = (unsigned char *)((ulong)DUART1_BA + 4);
 	unsigned char *dst;
+	unsigned char fctr;
 	ulong len = sizeof(fpgadata);
 	int status;
 	int index;
@@ -203,6 +204,15 @@ int misc_init_r (void)
 	out_8(duart0_mcr, 0x08);
 	out_8(duart1_mcr, 0x08);
 
+	/*
+	 * Enable auto RS485 mode in 2nd external uart
+	 */
+	out_8((void *)DUART1_BA + 3, 0xbf); /* write LCR */
+	fctr = in_8((void *)DUART1_BA + 1); /* read FCTR */
+	fctr |= 0x08;                       /* enable RS485 mode */
+	out_8((void *)DUART1_BA + 1, fctr); /* write FCTR */
+	out_8((void *)DUART1_BA + 3, 0);    /* write LCR */
+
 	return (0);
 }
 
-- 
1.5.6.3